Thanks for the video! You confirmed I did mine correctly!
@Vassmotorsports4 ай бұрын
Thank you very much and Thanks for watching Vassmotorsports, hope you enjoy my and Jasper's channel
@user-rv5fn2vv3h4 ай бұрын
Awesome video Steve.
@Vassmotorsports4 ай бұрын
Thanks alot buddy
@KayLee-wl9oz2 ай бұрын
cant wait to see it finished I know you can do it
@Vassmotorsports2 ай бұрын
😀
@tonyt880726 күн бұрын
When I pulled my lower three triangular plates and a burnt rubber somewhat gasket stuck to one of the plates fell out. I haven't found what they are from yet.
@Vassmotorsports26 күн бұрын
That definitely sounds like your exhaust.Flappers that are in the wifi one set on each side under the elbows coming off the risers, I have a video of pulling the out drive to do a Gimble bearing and Ran into the same thing so I replaced the flappers in the video,thanks for watching Vassmotorsports and hope ya check out some of my other videos. kzbin.info/www/bejne/n6HVYaxrnbmdiposi=BWKujSXz15B4lxX3
@davidd66354 ай бұрын
Is there an O ring at top of shaft below splines? Thanks for video. Need to do this on my boat.
@Vassmotorsports4 ай бұрын
No , the upper half has a seal in it that slides over shaft when reassembling , thanks for watching Vassmotorsports hope ya check out the channel and good luck with your impeller, it's a simple job
@williamd5988Ай бұрын
So no gasket cement?
@VassmotorsportsАй бұрын
no sir. just clean surface and put new gasket , it will seal , its open anyway and not closed system like on an engine or something, thanks for watching Vassmotorsports and hope ya check out some of my other videos