Yes you can do it yourself for the cost of a new blade. Restore the fine chipping again.
Пікірлер: 21
@tomlewis36584 жыл бұрын
Thanks. This is helpful. Mine is a model 452G709 - very similar to this one, but with a Briggs OHV engine. I bought it in 2007. I have never changed the blades, and today, after trimming some dead limbs from a Japanese red maple tree, I REALLY need new blades. Now I see that this is a straightforward process.
@freedomisfromtruth4 жыл бұрын
You'll breeze right through it.
@johnjude26853 жыл бұрын
Metrics Allen and half inch inside, Yeah them had me going nuts yesterday. Thanks mine was just a little dull. Thanks for the teaching Sir
@freedomisfromtruth3 жыл бұрын
Great Job
@J4TiDotCom3 жыл бұрын
Its nice to have good students
@carolynloshaw16653 жыл бұрын
Nice video. Thanks for making it
@J4TiDotCom3 жыл бұрын
Thanks for watching
@awakenedsapien99622 жыл бұрын
How do you replace the coil? I couldnt figure out how to remove the bloody fuel tank to get to whats underneat.
@UbayLanas3 жыл бұрын
Thanks for posting this video. It gives me a full idea of how to replace my MTD Chipper/Shredder machine. By the way, where did you order the blade? Do you think you can link me to these parts? Thanks in advance. Cheers
@J4TiDotCom3 жыл бұрын
I found the blade with search for MTD online, but a local shop also had the blades I think they do mailorder if you still need it.
@freshofbreathair14764 ай бұрын
How to remove the other blade on the other side?
@mikeditomaso44514 жыл бұрын
I think the original part blades are probably better than some after market replacement blades you find online.Original part is about $50.00 per blade and some online replacements are $15.00. There must be a difference in hardness and quality for that price difference.
@J4TiDotCom3 жыл бұрын
I used several and the $15 blades did hold up fine.
@johnjude26853 жыл бұрын
Should have only hold the Allen and turning the nut.,I tried also the Allen and rurnt it also
@lakemarine4844 жыл бұрын
What was that nut that fell off. Did you replace the shredder blade too?
@J4TiDotCom3 жыл бұрын
The nut is for rod to hold up the chute.
@awakenedsapien99623 жыл бұрын
Any video on how to remove the gas tank and replace the coil please? Thanks
@J4TiDotCom3 жыл бұрын
Thats would be by a small engine guy.
@trimainemodgan7999 Жыл бұрын
Hey buddy just look where your oil fill is there is two bolts and two at the bottom the tank will slide to your right then it will come off and the rest you will see . Note when readjusting the coil take a business card place over the magnet and slide the coil till it touches the card and tighten it up if you still have no spark disconnect the plug to your kill switch and you will have spark but you will have to disconnect spark plug boot to shut it off you should have a rubber boot on it so you will be fine to touch it to unplug it ONLY IF THE RUBBER BOOT IS ON IT ONLY