Replacing a Clutch on a Honda Ctx200/XR200/CRF230

[@billsmith4368]

Good video. I learned that using an impact wrench is the way to go to remove those two special nuts without having to use a gear jammer. It's also the trick for getting it back on. I did see in another video someone put the rings on that gold thing and then put it into the basket. Seems that would make it easier to put the rings back on. Rather than buy a gasket, I'm going to use Permatex liquid gasket product to make one.

[@danieldickson7812]

Yeah impact wrench defently the way to go id be lost without it yeah I used jb welds silicone gasket in a tube on another ctx200 clutch cover worked very well

[@elysotna79]

Excelente video 16:12

[@walkerblackwell3846]

How many foot pounds do you tighten your spring bolts to?

[@nickross6537]

what size clutch basket bolt remover are you using

[@ryu1014]

IS THE CTX200 AND XR200R(BRASIL) VERY SIMILAR? ONE THING I NOTICED WAS XR200(BRASIL) DOESNT HAVE A KICK START , EVERYTHING ELSE LOOKS REMARKABLY SIMILAR !! PLEASE LET ME KNOW IF U KNOW THE DIFFERENCE... GREAT VIDEO!

[@danieldickson7812]

Hi there all the ctxs I’ve had/ worked out are made in Brazil thanks 🙂

[@ryu1014]

@@danieldickson7812 thank you, can you elaborate. What is similar brother? Electric harness? PRO-LINK repair kit? Wheel bearings, engine bearings ? Shock? Thanks in advance again.

[@danieldickson7812]

@@ryu1014 I’m not sure sorry

[@Samboeky]

Hey man. Question... did you have the bike in neutral or in gear when removing the lock nuts. And did you use a gear jammer? cheers mate, good vid

[@danieldickson7812]

Hi there just put it in gear and used an electric impact thanks

[@aussiefarmer8741]

I was kind of hoping to see how that cover went on, Mine gets to a certain point then gets hung up near the kickstart spline an de compessor I dont have a manual. any tricks??

[@danieldickson7812]

I had somthing like that happen the shifter mechanisim had poped out a bit slightly causing the case not to go on all the way tapped it back gently then was able to get it on holding the foot brake down

[@henrygarromora7654]

Are de same in this models?

[@transamn8936]

Any other specialty tools required other than the 20/24mm clutch socket? Thanks

[@danieldickson7812]

Nah just a just a socket set helps thanks

[@flamingnothing]

What are the 2 thinner pieces you put in after all the plates and fibers??? I can't find them for sale anywhere or what they are called

[@danieldickson7812]

The big washer ring looking things. ? I’ll have a look online

[@danieldickson7812]

Ones called seat judder spring and the other ones called spg judder here’s a diagram your local Honda shop should be able to get them for you www.westcoastmotorcycles.com.au/partFinder/fiche/honda/2016/ctx200/clutch

[@flamingnothing]

@Daniel D thank you. For some reason they werent on the diagram when i found it on hondas website Edit: even on the website u used it is not there for the xr200r. All the videos ive seen have them but i havent opened up my bike yet to see if it does. Apparently it cant hurt it to leave it out

[@gbsavc]

Nobody shows how to put the kickstarter compression thing screw on. 😢

[@danieldickson7812]

I’ve heard quite a few people have trouble with that

[@spiral-editz9313]

6:38 what tool is that

[@danieldickson7812]

20/24 mm clutch tool socket