Replacing the Ball joints

Today we disassemble the Dana front end in the 1983 Chevrolet K10 Apocalypse truck and remove the old ball joints. We check out the wheel bearings and the U joint at the same time. We will be using all Moog parts on the project for ball joints, tie rod ends and any U joints as they have worked well for us in the past and they are guaranteed for life.

[@andrewwilliford114]

Awesome. Thank you. Took me like 6 hours haha

[@aroundthehomesteadwithsuer3497]

Well they can for sure be a pain in the butt especially if there is any rust on things

[@samferrugia]

Straight forward.. I like it.

[@aroundthehomesteadwithsuer3497]

Thank You

[@heelerdadadventures]

Helped a tremendous amount, thanks so much for the detailed, informative video.

[@aroundthehomesteadwithsuer3497]

Glad you found it helpful

[@donaldmac36]

What detail there is no detail the cameras 25 feet away

[@stanlkl]

Very helpful, thank you.

[@ugna2773]

So cool

[@aroundthehomesteadwithsuer3497]

Thank You

[@mr.lawrence6627]

8X Is Very Annoying

[@aroundthehomesteadwithsuer3497]

We do apologize for that, We never know the balance between a really long video, cutting a bunch out or speeding up the video.

[@donaldmac36]

Next time move the camera up closer so someone can see exactly what you’re doing. Nobody wants to watch you just work.

[@aroundthehomesteadwithsuer3497]

Thanks for the input, we are always working to make better content!

[@alindragulindotcom]

Was the front drive shaft an issue with the lift?

[@aroundthehomesteadwithsuer3497]

No it fit just fine, I think if you had done any more than 4 inch it would be an issue though