Revamp Your Yamaha Blaster Gen 1 (1987-2002) Wiring Harness And Eliminate Tors, Key & Oil Light!

/ wrekkedoffroad / @vermontlife www.buyjimmyabeer.com/
Did you know... 83% of the channel viewers aren't subscribed. If the content helps you save on repair shop costs, and you think the quality is good, help me build the channel by subscribing and/or buying me a beer, or 2 or 3... I appreciate it.
Buy Jimmy a Beer!
www.BuyJimmyABeer.com
Support the fun by liking and subscribing bit.ly/2kPku2P
This is part 11 in the series.
Sometimes progress is fast. Sometimes you spend a long time on a detail... Full Yamaha Blaster wiring harness walk through on this Gen1. This time I unwrap the entire harness and remove the Tors, key and oil indicator light wiring.
Additionally I go through converting the harness over for DC lighting with a DC regulator and removing the AC regulator. (Stator already floated in another video.) Prep work that will pay off as I work forward.
Finally I install my new Tusk Extendable Rear Axle while I wait for another set of power coated hubs.
It's taking shape.
My thanks again to the below companies. This project would not be moving forward without their innovation and support of the Yamaha Blaster platform and #savesportsquads
DirtFanatics.com
HPMPowersports.com
CTI (Cronetec.com)
SwopeRacing.com
RaceMetalSmiths.com
I referenced a video on floating your stator to create a DC circuit:
How to Float your Stator for DC LED lights - • Upgrade Your Yamaha Bl...
#ATVRepair
#twostroke
#yamahablaster
00:00 Introduction
08:28 Electrical Clean Up
40:39 Tusk Extendable Axle Install

[@vincenta.6168]

Thank god there is someone on the internet who can explain this type of stuff 😂

[@jayd879]

Another great video 👍

[@joshelkins5805]

I absolutely adore you for making this vido and making so much detail i wouldve never been able to get my blaster right without your help truly grateful ❤👍😁

[@VermontLife]

Glad it helped you get back out and riding. :)

[@josephmontes815]

Thank you a ton man really appreciate this vid I got my blaster to spark finally after replacing the stator and coil new cdi new handle bar switch and no spark until I went Through the wire harness and was about the replace the harness thinking it was bad from sitting outside for years

[@jarrodvhcommodore89]

Keep up the good work and cheers for doing it all in detail, legend 👍

[@jarrodvhcommodore89]

Awesome as if you show good footage of how it handles on trakls etc i may do this to my 05, from qld aus 💯💯

[@VermontLife]

I have paddle tires and a front end ski conversion. I haven’t tried tracks but that would be interesting to do!

[@Diegomartinez-gg3zg]

Could you make a wiring diagram with the done modifications?

[@VermontLife]

I plan to as I get further into the build and install this harness. Thanks for the note.

[@gzupnzdwn]

Great video. What rear shock did you use?

[@VermontLife]

Kawasaki KFZ400 shock.

[@gzupnzdwn]

Good video. What front and rear shocks are you using if you don’t mind?

[@VermontLife]

Works fronts and a kfz400 rear. I’d have to double check the front length but they are on American star racing +3+1 a-arms,