(Revised) Honda Semi Auto Engine Disassembly Part 2 of 2 (everything else)

[@eduardoterian352]

Wow thank you sir so much for these videos. I've learned thousands of things while watching them. Best Regards from Uruguay!

[@alexperel8435]

This attention to detail has been a life saver for me!

[@shaynekielmann]

Love this thank you for puting the time in to show how to take these little guys apart.

[@RRL551Dynamic]

Fantastic video, thanks very much for taking the time to share your knowledge.

[@jimmymatchubar4204]

Nice video ive learned a lot i hope you can upload videos about the ignition system or how c50 stator works because im working with my boss c70 motorcycle thats why im watching your videos..thank you mini motor😊😊😊

[@anarchist78]

Awesome guide this.. Thank you so very much for this.

[@chamjiskykhan8252]

I don't think there is any difference between both rockers arms. They can be interchangeable. Intake to exhaust and exhaust to intake. Except that valid point raised in video

[@mikemysicka7717]

Great video, thank you.

[@robertoorejel1220]

Gracias maestro good video

[@dennisbrouns1920]

Fantastic 🎉

[@jeremywolfe5954]

Would there be anyway that one of the nuts that is on the valve lash adjustment work its way loose and get into the engine? I mean where could a 9mm nut get to if it came loose in the head?

[@jtothefx]

Top notch

[@gustavomiller6645]

Hi, maybe you can help me with my engine rebuilt (CT70 K3). I found a similar pice to that umbrella metal cap but not sure where it goes. It does not fit on the studs holes. There is a hole on the crank case that fits...also there was a small o-ring that I guess goes together? I can send you photos if you give me an email

[@farleyj1999]

Can you tell me about this stator and cdi set up .I would like to convert my ct70 from points to cdi did you say it was 6 volts? What is motor off of.

[@sciscs]

Hello! My rocker shaft doesn't seem to have any threads to grab onto. That or it's just frozen from rust, may need to apply more pressure

[@Mr138AJ]

shalom, your rocker shaft's thread are maybe on the inside of the shaft groove, i dont know what your model is but normally long 12mm bolt can be put inside long enough to reach the threads on the inner side of rocker groove and can be pulled out. Of-course it'll take some pushing to take it out but its very hard to be rusty bcz there is engine oil always there unless the head was running dry. i hope that it helps.

[@ДедМудрый-щ1я]

👍