Рет қаралды 3,162
So, you bought an R.F. Explorer handheld Spectrum Analyzer.
You noticed the "Pre-Calibration" text that appears when you turn in on and you are concerned. What's up with this?
You wonder how to go about calibrating your R.F. Explorer to get the best accuracy you can.
Following the on-line instructions, it fails to complete every time. What's going on here? The problem is they left out a crucial step!
NOTE: == I do NOT reommend using anything other than 910 MHz as your calibration frequency.==
NOTE: The Sweep Points adjustment applies to the R.F. Explorer Plus. The standard version does not have this option in the computer software.
In this video, you will get the complete story!
Here is the promised link for the firmware and software downloads:
j3.rf-explorer.com/downloads
----------------------------
Time Marker Notes
00:05 Introduction
03:01 Calibration: Preliminaries
03:07 The latest Firmware & Software
04:08 Link for Downloads
04:49 Equipment Needed: Signal Generator
06:03 Calibration: Setup
06:05 Signal Generator Setup
06:26 Connections: Signal Generator to R.F. Explorer
06:51 Connect R.F. Explorer to Computer
07:04 Open the Computer Application
07:28 Computer Application Setup
07:37 Define Sweep Points
08:01 Set Center & Span Frequencies
08:39 Verify Signal is within Bounds for Calibration
09:25 Calibration: The Process
09:30 Configuration Tab
09:39 Frequency Calibration Section
09:44 Set "REFERENCE" Frequency
10:07 "Calibrate. . ." Button
10:12 Double-Check Signal Source dialog box
10:36 Calibrating: Steps 1 through 3
10:55 Disconnect or Power Off the R.F. Source
11:26 Calibrating: Steps 4 & 5
11:59 Calibration Complete
12:08 Verifying the Calibration is Successful
12:35 Final Comments and Toodle-Oots
-----------------------------