Riveting Copper & Jewelry

[@jeanwilcox3464]

Very good teacher and easy on the eyes

[@EgJewels]

Thank you Jean for watching my videos!

[@pattiklaus9580]

Best riveting demonstration ive ever seen! To be clear, peen side 1 until it begins to mushroom and then peen side 2. Back and forth as needed. And rivet should extend how far on each side - 1mm? Thank you for this tutorial!

[@ElieGhanimeEG]

Hi Patti, 1mm per side should be fine, the longer it is the bigger the half round top will be, make sure you practice on some scraps to get the feel of it. Thank you for watching 😊

[@lenastiward8657]

Thank you. How do we get a tool like you made to accommodate the top of the rivet?

[@lenastiward8657]

Where do you get the de-burring bit for your hand set?

[@ElieGhanimeEG]

Hi Lena, any hardware store should have it, there's different types but get the one with the counter-sink, you also can use a drill that's bigger than the hole you drilled but you have to use it by hand to have more control on the depth. Thanks for watching my videos!!

[@royhennagir7685]

Thank you.

[@EgJewels]

You are welcome Roy and thank you for watching my videos!!

[@simonpidgeon949]

Excellent video this is really going to make things easier, I’m just starting in jewelry making and every tip makes things more enjoyable, Thank you so much , I’m going to make some mushroom punch too , Cheers Simon 💯👍

[@ElieGhanimeEG]

Hi Simon, thanks for watching my videos and I’m sure you’ll enjoy what you’re doing. However, the KZbin channel you’re watching is the old channel and I can’t upload anymore videos on it, so please subscribe to my new KZbin channel, here’s the link. kzbin.info/door/3zSF2wGBv1pzuUYksU8d3w

[@simonpidgeon949]

@@ElieGhanimeEG Hi thank you, I’m now subscribed Best regards Simon

[@DianneCulbertsonJacques]

i have your hummingbirds and love them! Do you sell the tool you made and used in this vieo?

[@EgJewels]

Hello Dianne, I don't have any of these peening tools but maybe I should make some, if I do I will let you know. Thank you!

[@sarawelder1]

very nice clear explanations. thank you!

[@debbieskelly7298]

Nice video what did you use to put the little hole in the steel block.

[@BurninGems]

Wow, nicely done! I know, you should teach this someplace! 😉

[@EgJewels]

Thank you, I do teach at our club but metalsmithing it's only a hobby for :) This weekend I'll be teaching Faceting!!!

[@sylviaprudhomme5417]

Very good job

[@ataarjomand]

Too slow. Subject is good but a few times I fell asleep.