Honda Jazz Headlight Bulb Replacement || Headlamp Bulb Change. Headlight Removal Process.

LIKE | SHARE | SUBSCRIBE
Honda Jazz Headlight Bulb Replacement.
Honda Jazz Bulb Change.
Honda Jazz Headlight Removal Process
#jazzheadlightbulb
#jazzheadlightremoval
#jazzheadlamp

[@pianothatilove]

Thank you very much for the video 👍

[@diykhan]

You are welcome thanks 😊

[@davidmingay]

This is an interesting method. I did it differently by reaching round the back, pulling out the plug, removing the seal, undoing the clip, replacing the bulb, and putting it back together again. No tools required, and it only took less three minutes.

[@BerndtTost]

I had a 2003 Jazz. I changed the headlight bulb by accessing it through the wheel well. To change the right hand side turn the steering wheel full lock to the left. Go to the wheel well. Remove the positioning lugs that hold the splash guards in the wheel well. You will have enough room to access the headlight bulb and replace it. Then replace the splash guards in the wheel well and to the same for the left side but with full lock of the steering wheel to the right. No need to disassemble the front bumper and headlight assembly.

[@MarkHarmer]

Going to try that first! Thanks!

[@AN-ix9lg]

of course! :)

[@surfsusi]

Ich habe das auch so gemacht aber über den Radkasten ist es ein ziemliches gefummelt und zum Teil muss man blind arbeiten da es nicht sehr gut einsehbar ist.

[@nikolaanker5222]

Ich hab es eben über den radkasten gemacht es war nicht einfach aber ich hab es geschafft. Allerdings habe ich auch kleine Hände. 😃

[@ellabennett4504]

Thank you!!!

[@DoomNedwob]

Many thanks DIY 😁 I tried the handbook through the wheel arch method and after much swearing tried your way instead to great success! 👍 I managed to get the bulb out the other way, but it was trying to get new one in and the clip down, never mind the rubber boot.....arrrgh! 😂

[@MagicWok]

Well done Honda on designing a really annoying way to replace a bulb that super easy in many other cars.

[@juliangall]

So helpful. Thank you very much. Just been sitting out in the wet road following your instructions. New bulb now successfully fitted.

[@nesperndlovu5953]

😊

[@angelojosephhh]

Thank you Mr Khan. U helped me to do lamp replacement job so easily and saved .e couple of 100 dollars

[@diykhan]

You are welcome thanks

[@markpeti]

Helpful video thanks, I changed the bulb without removing the lamp. But I wouldn't be able to do it without watching the video as there is not much space so I did it by touching rather than looking, but as I say seeing on the video what needs to be done was much help

[@diykhan]

You r welcome

[@christophersmith7891]

Great video! Had to change 2 bulbs now and watched this video both times. Thanks so much 🙏🏽

[@diykhan]

You are welcome thanks

[@cchplays8182]

Great video, with your help I just changed the sidelight on my 55 plate Jazz....I tried pulling the wheel arch fairing down but could not get my hand in.....so I took the entire lamp out as per your advice.....Excellent, job done thank you very much.

[@diykhan]

You are welcome thanks

[@thefiremandave910]

Thanks for this. I did it today. It was much easier after watching the video.

[@diykhan]

You are welcome 😊

[@sambacko4188]

Thank you DIY Khan. Was very easy using your method. Worked a treat 👍🏼

[@diykhan]

Thanks

[@frenchy6254]

I’ve just used your video to help me change all 4 bulbs. It was an awesome video and can’t believe you don’t have more likes. Thank you so very much for taking the time to make this. I hope you have a great festive season. From Keith in the UK.

[@diykhan]

Thanks for your best wishes. Have a lovely Xmas

[@dreddy02]

The Jazz manual, explains it, you just go in via the wheel well, remove two clips and your in to the back of the light,, no need for all this malarkey! ;o)

[@wuseling]

...well I always change them from behind (blind) ... the bulbs often fail (2009 model, maybe there is more space)

[@thepoofication]

Just for info: I was able to do this on the driver side without complete disasembly, was very tight and you need to be relatively dexterous with you fingers. I have medium sized hands (181 cm). Maybe it's usefull to some, so like the comment for others.

[@ivelin888]

Very comprehensive, thank you!!

[@diykhan]

Thanks 😊

[@jilumiah]

Thanks man really helped, but what awful design by Honda.

[@diykhan]

Yes true 👍

[@aidanh5215]

Thank you so much (in advance) Mr Khan. What an insane palaver I've got to look forward to...

[@aidanh5215]

Done. Thanks to you. Who designs this idiocy?

[@diykhan]

Good

[@btinternet009]

Good job thanks

[@12345anser]

just changed both bulbs from wheel side for left bulb turn wheel full to right .....and remove 2 studs with screw driver by simply plying out....then push down the mud guard and put arm in and feel instead of looking....remove cable then remove rubber then remove clip by unhinging the clip outwards....then remove bulb....replace new bulb by turning round till it fits in hole and put clip back...then put rubber back and plug cable same with right side ..turn wheel full left...then start remember to wear gloves if possible ...and turn car off to avoid charging yourself😅

[@ismailali3250]

If possible pls make more vids on the jazz thank you

[@Sir_Veza]

Muchas gracias, amigo!!

[@diykhan]

Thanks 😊

[@ismailali3250]

Keep up the videos very helpful earned a sub

[@artcartoonworkofficial]

Good work ilike I'm new friend sappurt you

[@ismailali3250]

Thanks for these videos

[@jeshlee]

Thanks mate. Very helpful

[@diykhan]

You are always welcome 🙏

[@itx_me_hassu13]

6 Lk Amazing ♥️ Stay Connected

[@diykhan]

Thanks

[@ibrarali9369]

Thanks, good explanation 👍.

[@diykhan]

You are welcome 😊

[@Misiunass]

Well done. Thank you very much!

[@diykhan]

You are welcome thanks

[@scorpiistar]

great video m8 thankyou 🔥📈🔥📈🔥📈

[@diykhan]

You are welcome thanks

[@amnakhirdtechvlog8470]

Good video nice I like it Full watch nice video great I like it Amazing ♥️ Stay Connected good idea

[@diykhan]

You are welcome Thanks

[@a.r.7699]

You are Master!!!!!! 👍👍👍👍👍👍

[@diykhan]

Thanks very much 👍

[@waschbaers_werkstatt]

Thanks 🔧

[@diykhan]

You are welcome thanks

[@Michael-dp4fo]

What size is the side light?

[@jojojohanes3310]

Good job, but no need to remove headlight to change light bulb

[@diykhan]

There wasn't much space behind or a window in the wheel arch to get to to build Thanks for your support

[@RadioNul]

Wheel arch method is near impossible

[@jojojohanes3310]

@@RadioNul I agree not an easy to do blinded from the wheel arch but if you know where to press and what to unhook than it’s not that hard. When I change it next I will make a video from it. Good luck in changing

[@diykhan]

Yes i agree. For beginners it's a mission to change a bulb from under the wheel arch

[@sambacko4188]

Tried wheel arch method and couldn't do it. Tried your method and took 10 minutes and was very easy. Thank you very much Khan :-)

[@JustWilliams]

Great video. Thank you.

[@diykhan]

You are welcome thanks

[@haniraja1]

Very well done sir g

[@diykhan]

You are welcome thanks

[@philvan4113]

Thanks for the video

[@diykhan]

You are welcome thanks

[@JakobusVdL]

Phew, that looks fiddly! Honda didn't plan on the headlight bulbs being changed easilly. How do you check the headlight alignment is correct after fitting?

[@fionatinker23]

Agree - I am watching this in horror! Mr Khan makes it look easy, which shows he's a master craftsman. He takes his time, explains it all clearly. Whoever at Honda HQ thought this was a great design for a headlamp is most certainly not a master, more a sadistic novice! I'll have a go but I can see this being a garage job. Just to change a b****y headlight bulb.

[@JakobusVdL]

@@fionatinker23 Hi Fiona, I did the bulb change on my daughters Honda Fit. I did it in a few hours on my drive. I found that taking the whole nose panel off the car, then rmoving each headlight unit off, and then changing the bulb was straightforward. and I took the chance to clean the chassis, radiator etc, and give the headlamp lenses before putting it all back together. I turns out headlight alignment wasn't a problem it all seems to go together with no adjustment. So if you have the time, and a set of screwdrivers and sockets, it is straightforward. However, the person at Honda who designed that set up still owes me a pack of beers - so impractical.

[@fionatinker23]

@JakobusVdL thank you for the encouragement. I will try at the weekend. Such a simple thing shouldn't be so complex though. I like the idea of cleaning underneath too. Good tip.

[@JakobusVdL]

Great@@fionatinker23! Let me know how you go.

[@fionatinker23]

@@JakobusVdL I've wussed out! The bolts and screws are really tight and I don't have the strength in my hands to give it a good enough whack to loosen. WD40 laughed at me and noped out :-) Plus, it is snowing and freezing, so I am just going to be a pathetic eejit and take it to the garage on Monday. I do - very much - appreciate your helpful comments and Mr Khan's great videos though. Have a lovely festive season, both of you.

[@kdz6775]

Thx my friend

[@diykhan]

You are welcome thanks

[@TheSpannerLab]

Thanks buddy.

[@diykhan]

You are welcome thanks

[@adammillsindustries.]

Nice. I guess side light just twists out?

[@diykhan]

Hi Yes thats just a twist out type

[@dario-em9lc]

Thanks 😊

[@diykhan]

You are welcome thanks

[@saiedaltinawi6914]

Super

[@diykhan]

You are welcome thanks

[@silverback1540]

Thanks mate like & sub

[@diykhan]

You are welcome thanks

[@phd650]

Pas besoin d'enlever le pare choc lol y a de la place

[@Blemagic1]

but why ? ^^

[@oursblanc6477]

Merci !

[@diykhan]

Thanks 😊

[@bigbadlouroma]

What?

[@nikolaanker5222]

Thank you so much for this Video 🙏

[@diykhan]

You are welcome thanks 😊