How To Rebuild the Top End on a 2019+ Kawasaki KX450 | Part 2: Engine Assembly

[@p.t.3726]

What a nice and helpful videos! So good to watch on Friday evening. Now I want to try it myself, even though I don't own a Kawasaki.

[@renemagana4713]

Did my top on rebuild on my kx450sr . Great video . Reason why i sent it and did the rebuilt myself . Dont be scared guys go for it . Take your time . Make sure you have all the necessary tools and parts ! And everything else will be smooth .

[@32brostv23]

I just got my kx450f 2017 rebuilt and road it back home but next morning when I turned on the choke and hit the gas it turned off and lost compression do u think u can tell me why?

[@djp3819]

Great vid. I was wondering why you didn’t replace the cam chain while you were in there?

[@buddywilson104]

Very Helpful video(s). Thanks!

[@NEWF2195]

I’m assuming the same for the 2021?Would like to see a video for the bottom end.. chain snapped and Smashed my case and hydraulic clutch :(

[@Mrfurballs]

did you over tighten the chain ?

[@MrThorney1987]

Hi great video ! Why do the piston rings face toward the intake valves ?

[@darrenjones6965]

Hi what is the recommended hours for a top end rebuild on a 2019 kx 450 . If you’re only a intermediate rider . Thanks Darren.

[@domvaccarello992]

80 hours

[@darrenjones6965]

@@domvaccarello992 how many hours would you recommend to to change the clutch plates . Thanks Darren

[@domvaccarello992]

@@darrenjones6965 about every 30 hours. 40 of you are hard on the clutch. Clutches are mostly about feel. If you feel it slipping then replace it. Key to keeping your clutch plates good is frequent oil and oil filter and screen changes

[@domvaccarello992]

@@darrenjones6965 I’m sorry. I mean about every 40 hours and 30 if you are hard on the clutch. Got it mixed up lol

[@darrenjones6965]

@@domvaccarello992 great advice thanks.

[@spilledpickles]

when i go to do my two full rotations the motor locks up at some point and won't let me to go further - all lines lined up when i installed what could it be?

[@edwinramirez7817]

Cam chain is binded up

[@AlexSilva-dk2nk]

You are the best man thanks

[@damonyeany9276]

How different would the top end rebuild be for a 2021 kx 250 xc

[@timmockford239]

0 difference. Only difference between bikes is rear tire, kickstand and softer spring rates.

[@NickW90]

Why would you not replace the timing chain when doing the top end?

[@rmatvmc]

If it's worn out, binding, "stretched", or has a lot of hours, then sure. I would recommend replacing it when it's time to rebuild the bottom end, but if you are waiting that long to do your top end, then definitely get it done. -Charles

[@BrowardBikelifeTJ]

What pound wrench is that

[@rmatvmc]

There are two torque wrenches used in this rebuild. One goes from 10-80 ft. lbs. and the other one is an inch lb. torque wrench.

[@juannnn8074]

Buen video saludos de Argentina.

[@AlexSilva-dk2nk]

Very nice 👍

[@fkn16v]

Assembly lube goes on bearings, not rings or the jug. rings and jug get engine oil.