Robart P47 #13, Dummy Motor #3

[@mohammads4304]

Nicely Done, Don Mohammad

[@danpos1971]

Very nice work. As always :) Very clean looking job.

[@TheEnigmaThatIsDrIce]

Thank you Dan

[@n1114v]

looking good. are you going to compete with her or just sport fly?

[@TheEnigmaThatIsDrIce]

I hope to finish her in time to take her to the Scale Masters Finals in Davis, CA in 4.5 weeks. I'm pre-qualified for Pro-Am Pro due to my 2nd place finish at the national finals in Houston last year...so I hope to do 1 place better than that this year...:-)

[@robcrawford9657]

Nice Don thank's for posting,can i ask what resin you use with the chopped fibers? and do you find it separates from the glass fuse easily? i have to bond two halves of a glass fuse soon and just researching what to use,epoxy,structural adhesive ect,thanks again.

[@TheEnigmaThatIsDrIce]

Rob, I don't remember exactly what it was probably West systems. It's hard to go wrong if you're using West epoxy.

[@andrewnixon9167]

Love your videos, any current news with your Corsair project?

[@TheEnigmaThatIsDrIce]

I intend to finish the Corsair as soon as this P47 is completed. Hold yer breath.

[@Stone177]

Robart stop selling the P-47.

[@TheEnigmaThatIsDrIce]

I don't think so: robart.com/collections/airplanes

[@Stone177]

My friend bought about 5 of the P-47 and was told my Robart they will stop caring the P-47 line. Robart is going to start caring Gator R/C plane.

[@TheEnigmaThatIsDrIce]

Well...that's too bad.