Robinson Racing Spur Gear Install E Revo

[@MDZzzzz]

great video. Every other installation video of this spur gear fails to show which way to position the washers!

[@HoosierRC]

Michael Doyle you are correct. So tough to find correct video

[@HoosierRC]

Thanks for the video.. Used it to install my spur.

[@NY69NOVA]

What kind of speed were you getting with that gearing setup?

[@tsenif]

How's it holding up for you? I'm doing some research on what stuff to get for my E-Revo 2.0. My transmission completely exploded, nothing salvageable. Looking into Robinson Racing parts & Jim's Bearings bearings

[@JoeOvercoat]

0:30 too late, already went there! now I am traumatized and skittish about tightening this Robinson Racing installation. :P BTW - Evidently the drive pin 3:09 that goes thru the input shaft for the Brushless edition of the E-Maxx is larger than the earlier Maxxes, and RRP provides different backplates accordingly.

[@benhemingsen8286]

Nice video, i keep destroying pinion gears on my slash 4x4. I even had one RR 8713 but the other half dozen were traxxas 13 t. Is there a certain mesh for hardened steel to hardened ? Please help.

[@awdsvx]

Nice information. I learned something. I don’t have an E Revo, but a 1/10 Summit. I subbed. I assume that the Robinson Racing slipper clutch will work on the Traxxas Summit, will contact the company before I buy. Thanks

[@HORRUS29]

I would have subscribed had you actually showed how to replace these parts.

[@teslacybertruck750]

Hi, is there a certain way the 3 clutch pads go? Because im not sure if I am putting them the right way..

[@continuecrushingrc3653]

on the factory/traxxas slipper? They have little nubs on them to help line up, but the stock revo clutch is a horrible design-the 3 pad thing they have is very difficult to set, and not very robust.

[@taevy12]

sir, how are the shockwave tires ? do they balloon much ?

[@continuecrushingrc3653]

Hey! The tires were decent, and I didn't have many issues with ballooning. 6s they expand, but it wasn't as bad as some I've seen.

[@josecruzdiaz5479]

Do you have parts number for the upgrade

[@ofircohen1378]

How much need to close the locknut?

[@continuecrushingrc3653]

Not much-I broke the other one trying to crank it down. I'd probably leave the cover off and test drive until you get it right.

[@stephenholtapp5946]

What scale is your car

[@continuecrushingrc3653]

this is the E-Revo, which Traxxas calls 1/10.

[@matthewlang659]

Were u running 6s?

[@continuecrushingrc3653]

yup. Toggled back and forth between 4s and 6s, but 6s is when it broke...well started slipping, and then I broke it lol