Excellent! I have wondered about a DIY version of the pipe cutter upgrade and you have done it well. I like the jaw chuck much better than the belt used by Plasmacam. I would like to know if you had any challenges setting up the X axis in proper ratio with the Y axis. I would love to see more about this setup.
@chaddoeseverything96503 жыл бұрын
Without seeing the left side I'm guessing the wire is pulled from the gantry and there is a 2nd motor attached to the chuck that is hooked to the gantry wire.
@robertdjohnson72423 жыл бұрын
Correct. The gantry motion is set to turn the rotary rather than move the gantry in this setup.