RotorFlight Configurator Rates tab animation.

RotorFlight Configurator Rates tab animation works fine, receiver tab does not.

[@AndWhoIsMakingMovies]

In RF2 this is fixed, both Receiver and Rates tabs work.

[@did3d523]

is it corresponding in flight or not same speed rotation ?

[@maverickgyrocopter2837]

I have this problem to arm the motor The maximum frequency of the PID loop is limited by the power of the CPU Processing. CPU load should not exceed 70% how can I solve this problem? thanks in advance for your answer

[@maverickgyrocopter2837]

A configuração no rádio e de helicóptero ou deixa como de avião? Bom dia

[@maverickgyrocopter2837]

Hello, I can't make my esc work already calibrating but even so it doesn't make the motor run... my motor and pwm

[@maverickgyrocopter2837]

Is the configuration on the radio helicopter or does it leave it as an airplane? Good morning

[@AndWhoIsMakingMovies]

Swashplate mix is in the FC, radio has airplane style controls.

[@maverickgyrocopter2837]

In stabilized mode it does not turn?

[@AndWhoIsMakingMovies]

Interesting queation. It works the same regardless of Angle/Horizon/Acro modes, maybe it should not show rates but rather absolute angles in angle/horizon mode? (BTW. All those modes are "stabilized", only differences is if it is abdolute angle or angle rate stabilized.)