Рет қаралды 11,759
Asalam o Alaikum Friends aj ki is video main apko dikhaya gia hy RST 25 Phase Failure Under Overvoltage and phase Sequence Relay kaesy kaam karti. aor is ki complete setting kaesy
ki jati hy aor is k connection kaesy kiy jaty hain. aor iska use kahan kahan par kai jata hy. So Is video ko dekhen aor enjoy karen.
Please like this video and don't forget to comment.
Thank You Very Much for Great Appreciate.
..... Attention Please .....
Some ideas, And Experiment can be Dangerous. And For that you don't Risk and Damage your self and the Environment, I am a professional in my business with a lot of experience!
Every video, even that is completed with compliance with the all safety measures. Enjoy the video and Eat the sweets.
WARNING:
This video is for demonstration and education purpose only. Each demonstration presents risk and hazards that must be fully understood before attempting. And should be performed
only by professionals.
Please Click On Blew Link for Subscribe our Channel.
www.youtube.co....
Please click on blew link and follow us on Facebook page
www.facebook.c...
Click on blew link and follow us in Twitter:
/ nadeemshahanvi
• UNI-T UTP3300TFL-II SE...
❤❤❤ About This Relay ❤❤❤
❤❤❤ Under voltage ❤❤❤
The desired under voltage limit can be adjusted down to -25% UN.
❤❤❤ Over voltage ❤❤❤
The desired overvoltage limit can be adjusted up to +25% UN.
❤❤❤ Asymmetry ❤❤❤
When adjusting over-and under voltage limit, the asymmetric limit is also adjusted.
❤❤❤ Time Delay ❤❤❤
The switch off time can be adjusted by the potentiometer “Time’ Delay from 0.1….5 seconds. With this function it is possible to adjust the time for the identification of the failure.
❤❤❤ Contactor Control ❤❤❤
If a phase fails during operation at load or one of the contacts of the contactor or circuit breaker is defect,(contact bounce or scorched contacts), RST 25 recognizes the failure, and
also the feedback voltage, and switches off depending on the setting of
❤❤❤ Time Delay ❤❤❤
The RST 25 controls the phase shift. If there is a phase failure during operation the angle from the feedback voltage is 30° and the RST 25 recognizes this failure.
***" More Electrical video "***
Lahore Orange Train ka Safar
• Lahore Orange Train ka...
Kia 3 years Diploma Karna Chahiy Keh Nahen (DAE)
• Kia 3 years Diploma Ka...
UNI-T UTP3300TFL-II SERIES DC Power Supply 0 - 30Volts 5amps
• UNI-T UTP3300TFL-II SE...
How To Find Washing Machine Motor capacitor wires
• How To Find Washing Ma...
Single Phase Motor Reverse Forward Connection / Yongsung
• Single Phase Motor Rev...
How To Check (SSR) Solid State Relay & How is it work
• How To Check (SSR) Sol...
Basic Concept of Two Way Switch
• Basic Concept of Two W...
Water Pump Connection with Two Meters and control with two way Buttons
• Water Pump Connection ...
Basic Concept of Two Way Switch
• Basic Concept of Two W...
What is a Function Of BCU (Bay Control Unit) Relay In Urdu - Hindi By Nadeem Shahanvi
• What is a Function Of ...
❤❤❤ Thanks For Visit Here ❤❤❤
#Nadeem_Electrical
-----------------❤❤❤❤❤❤-------------------
Thanks For Watching
Should be Done.
✅ LIKE ✅ SHARE ✅ COMMENTS ✅ SUBSCRIBE