Your explanation of “how” to cut those miters, grooves, and rabbets is exactly what I have been looking for and what most other videos lack. Appreciate the time and effort to explain these in detail.
@rusticanchorwoodworks6939 ай бұрын
I appreciate the feedback and leaving a comment! I need to get back to making videos!
@Hansaman586 ай бұрын
Nice! Looks great! I was stationed at Makalapa in the late 1990s and volunteered hours helping restore the USS Missouri. I have a teak deck plug. I’m retired USAF.
@rusticanchorwoodworks6936 ай бұрын
That's awesome! It's a great place to visit, you "feel" the significance, sacrifice and history when you stand over the surrender deck.
@jamesdelapaz83142 жыл бұрын
One day, I'll make one.. thanks to your video, i now have an idea on how to do that! Really detailed video! I love it!
@rusticanchorwoodworks6932 жыл бұрын
James, your the man! Thank you for the support.
@rusticanchorwoodworks6932 жыл бұрын
1st comment too!
@Bearboy09129 күн бұрын
Fantastic work. Excellent detailed explanation. Thank you! What type of fabric did you use?
@brianhmonks Жыл бұрын
Nice build. Love the car!!!!
@rusticanchorwoodworks693 Жыл бұрын
Thanks!
@Jimabair Жыл бұрын
I had planned on making the exact same one with the flag on the bottom center. Thank you for a great video
@rusticanchorwoodworks693 Жыл бұрын
Absolutely! Thanks for watching.
@JackCline-h5y Жыл бұрын
To make CA glue set faster put the glue on one side and spray a little isopropyl alcohol on the other. Sets in a few seconds.
@rusticanchorwoodworks6936 ай бұрын
Great tip I'll give it a shot
@ericjweber11 ай бұрын
For the Coast Guard flag in the lower right hand corner, what flag are you using, and are you folding it like a USA flag, or do you have to get creative to get the CG emblem centered on the triangle? Thanks, great and helpful video.
@rusticanchorwoodworks69311 ай бұрын
I had to get creative to get the CG emblem to look the way it did. Basically I cut out a piece of cardboard into a triangle and folded it with the emblem on the front and did what I could behind it. Thanks for checking it out!
@aaronthompson5906 Жыл бұрын
Awesome box! How does the back stay on?
@rusticanchorwoodworks693 Жыл бұрын
Thanks! Small nails spaced every 6" or so and on each corner. Or you can use small screws but you must drill pilot holes while being careful to drill straight otherwise you'll come out of the side.
@paulhugill5006 Жыл бұрын
Great video thanks. Why not use a miter saw to cut the bevels?
@rusticanchorwoodworks693 Жыл бұрын
The miters come out a lot better for me on the table saw. My miter saw has too much deflection when making precision cuts.
@robertgasper24957 ай бұрын
Thanks for the answer. I was wondering the same thing. @@rusticanchorwoodworks693
@matthewwright4188 Жыл бұрын
Was that a Roman ogee router bit you used? If so, what size?