Saab 9-3 Ionisation Module Problem - P1312

P1312 Saab 9-3. Saab 9-3 ionisation module problem #Shorts
ionisation
ionization

[@caractacusbrittania7442]

Another great find,

[@caractacusbrittania7442]

Only just got round to doing this

[@chrisgunnphotography]

Thanks, noticed I had corroded pin the other day cleaning solved my issue!

[@fat2oy]

Don't have any codes or problems as yet so ordered some grease as a preemptive measure, it came today absolutely no corrosion on connector but blathered it and plugged it back in. I also did ecu connectors and abs module before I forget where I put the tube. Great tip to keep problems from turning up me thinks

[@ginawilliams2204]

Brilliant

[@micah1121]

OMG THANK YOU!

[@markusstrom5203]

Hi Cyclone, love your videos, they've helped me so much wifh my 2004 9-3 vector! Recently had the water pump replaced due to leakage and I got the car back last week. A couple of days ago it started to get occasional misfires when accelerating, and at the same time I got the p0101 code - MAF sensor getting odd values. Should I look for vacuum leakage or replace the MAF?

[@kennethmoore5034]

Thanks give me the information I just bought me a Saab 93 about two weeks ago. your information help me help me fix my car thank you

[@lutfialagoz762]

👍😎👍

[@antonypost19]

Ive been working on saabs for 8+ years now and usually when i get these codes its 9 times out of 10 bad coil/coils. Ive never once replaced ion module just replaced plugs and coils and never had a car come back for it not fixing the problem

[@ianrobertson4946]

just recently got the p1312 code and going to try this. I took the connector out and cleaned the pins as well as cleared the code and it didn't come back instantly like normal. I will update after i drive it home.

[@bpbanpetkovic8972]

Hi dear,

[@marcustoomey8631]

I have a lot of brown stuff inside my would that be the head gasket gone

[@georgewaller500]

Hi. Firstly. Love your vids. Gonna be using your oil change video this weekend.

[@gltwn]

My 9-3 was throwing P1312. I cleaned the connectors with contact cleaner, cleared the code, and went for a long drive. Code did not come back!

[@gman8578]

I currently have this code. I was going too change the spark plugs.I would like too perform this procedure also. I hope everything goes well.

[@lspd5916]

Great video! Quick question, my 9-3 B207, jerks a bit when I idle. Often when the car is warm. When it jerks, the RPM also drop a bit for a second. This dosnt happen when i drive the car. Thoughts?

[@crybum4137]

I have an 2007 Saab 9-3 2.0T it cranks but no start starts with starter fluid. Got it scanned got code “P0725” engine speed input circuit” what do I have to replace? Speed sensor, CPS? help.

[@mohamedsaed2704]

I'm in Canada and we don't have 'Electrical Quick Clean' .. Can I use WD40 instead..?

[@scottboughton2699]

solved my p1213 lying wires for coil 1 first then 2-3-4 so wires for coil 4 are on top of other 3 tryed without sucsess changing coil pacs 1and 2 new plugs and swapping knock sensor with known working one without sucsess code not came back for 3 days