Oblique view - 4 - Engineering drawing - Technical drawing

[@georgeyjjj]

how you draw an upright position of this?

[@joelvides9223]

Why are you not reducing the distance by half...if you have drawn using 45degrees?

[@technicaldrawing]

Scale is only for Length , width and height

[@kunj1_vora]

Sir just one doubt, You have made this diagram at 45° or 30°?

[@technicaldrawing]

45

[@kunj1_vora]

@@technicaldrawing ok sir, actually I did from your textbook which mentioned 30°.

[@technicaldrawing]

Yes you can do that

[@kunj1_vora]

@@technicaldrawing Ok thank you, sir!!!!!!!!👌👌👌👌

[@forest9173]

Sir is this a cabinet or cavalier?

[@technicaldrawing]

Cavalier in cabinet you take width half

[@lankajagadeesh8608]

Sir bolt and nut drawing plz .....

[@technicaldrawing]

Cbse portion?

[@lankajagadeesh8608]

Iti fitter en drawing sir bolt and nut