Crankshaft Position Sensor - Nissan Micra K12

[@screwsnutsandbolts]

Thanks for watching my video. If you found this or any of my other videos helpful, maybe you could consider supporting my channel by using the ‘♡ Thanks’ button below each of my videos. Your support would be greatly appreciated, thank you ! 👍 Screwsnutsandbolts

[@jean-marcknight8816]

I just id a P0335 default (using a basic obd and Torque app) I am not a mechanic and looking at other confusing videos, I didn’t feel like doing it until I found yours which is straightforward and clear as a mountain lake. I got me a new crankshaft sensor and did it. Well done sir 👍

[@screwsnutsandbolts]

You're very welcome, thanks for watching !

[@asadzaman5373]

Can you advise me where you bought the crankshaft sensor from?

[@jean-marcknight8816]

I ordered it in a shop but usually, I use autodoc

[@Sub-aru94]

@@jean-marcknight8816 original or some replacement?

[@Karim_Belgique]

Is this the vehicle speed sensor (VSS) on the transmission? I'm looking for it.

[@producer7798]

Thanks 😘

[@screwsnutsandbolts]

You're welcome !

[@SSATASS14]

Bonjour et merci pour vos vidéos elle mon bien aidé. Je voulais savoir si vous saviez ou se trouve le capteur pmh par hasard ? Merci et continuez 👍

[@screwsnutsandbolts]

What is pmh sensor ?

[@harshitgupta885]

Can you help me with the part number of this green connector. Mine is worn out

[@screwsnutsandbolts]

It's very hard to find. This is the best I could could come up with: www.aliexpress.com/item/10000356135177.html

[@saddamhoussyen1900]

شكراً

[@screwsnutsandbolts]

You're welcome.

[@rajirahmto3964]

Please i have replaced the same part as in the video but the new part didnt work. The engine dont star. If i put the old one the engine start. The old part and the new one look from the outside exactly the same. I dont know what is the problem.

[@TorrenJohnson]

Hey can I ask you a few questions on your nissan. I have a nissan quest but I'm confused on something

[@kaidi_jpg]

Hello, i have a missfire on cylinder 3, remove all spark plugs and ignition coil on this cylinder but i've still the same problem 😔

[@screwsnutsandbolts]

Does the engine have high mileage ?

[@kaidi_jpg]

@screwsnutsandbolts I have 181.000 kilometers. Is it a high mileage for 1.2 80hp engine, i dont know 🤷

[@screwsnutsandbolts]

No it's not too high. There could be other issues like a clogged or faulty fuel injector, a vacuum leak or even a compression issue with cylinder 3. It's hard to be sure

[@kaidi_jpg]

ok, so its could be everything 😬

[@saifyhyper]

Hello, I have a 2006 Nissan Micra that only starts for few seconds and switche off again. I have changed plugs, coil packs, camshaft and crankshaft sensor but the problem is still there

[@saifyhyper]

It stays idle for few seconds and as soon as I touch the accelerator peddle it looses all the power and shuts off

[@screwsnutsandbolts]

It could be a faulty fuel pump, a clogged fuel or air filter among many other things. You'll probably need to take it to a garage to have the problem diagnosed

[@ssss-df5qz]

Immobiliser

[@batuadjas4362]

My vehicle does not have a crankshaft sensor cable, how can I find it? Nissan Micra k12 2004 1.2

[@batuadjas4362]

Please help thank you

[@screwsnutsandbolts]

I don't know where it could be or why somebody would remove it, sorry

[@batuadjas4362]

@@screwsnutsandbolts There was a 3-pin crankshaft sensor in my vehicle, can I use a 2-pin crankshaft sensor instead?

[@screwsnutsandbolts]

I'm not 100% sure but I think you would need to use the same as the original for it to be recognised by the engine mangement system.

[@AhNigqa]

Can A Bad Crankshaft Cause K12 Micra To Misfire ?

[@screwsnutsandbolts]

Yes it can be one of the possible reasons for an engine misfire

[@keemoak.]

My micra is cranking but not starting I checked the fuel pump its working fine i checked all fuses they are all fine then i removed the fuel injectors and tried to start it and it wont spray fuel and removed one coil to see if there is spark i didnt get any spark So can the crankshaft position sensor do it? Or is it the ecm?

[@screwsnutsandbolts]

It's one possibility. They're relatively cheap to buy so it might be worth replacing it first

[@wowabilaty]

Hey did you get to the bottom of the nonstart? Been trying to get some form of life out of mine for a couple of days now. Doesn't seem to be the crank sensor for me

[@mushtaqqqq]

My car doesn’t start but start if I take off crank connector what does it mean? Where is the problem?

[@screwsnutsandbolts]

Crank connector ?

[@mushtaqqqq]

@@screwsnutsandbolts yes

[@screwsnutsandbolts]

I don't know what you mean by crank connector ?

[@mushtaqqqq]

@@screwsnutsandbolts ….I mean electrical plug which fits on sensor

[@screwsnutsandbolts]

Normally a car won't start if you disconnect the crankshaft sensor so that's unusual. I'm not sure what's happening there. You'll probably need to have a mechanic have a look at that.

[@burhan.guler1]

P0335 P0725 code ?