Seadoo | Installing Fuel System | Syncing Oil Pump and Throttle

This video teaches you how to:
1) Bleed and prime your oil injection lines
2) Synchronize dual carburetors
3) Set the throttle slack
4) Synchronize the oil pump
Make sure do final throttle and oil pump adjustments after setting a smooth idle.
#seadoo #seadoolife #twostrokelovers #mikuni #pwc
PWC in the video: 1997 Seadoo GSX
00:00 Introduction
00:53 Bleeding the oil line
01:58 Priming the injector lines
03:33 Synchronizing dual carbs / installing carb linkage
05:13 Setting the throttle slack
07:04 Synchronizing the oil pump

[@momo6193]

This is awesome! First time working on seadoos. This made it too easy! Thanks again for making great clear videos.

[@iridevfr]

That’s a good video bud! Nice older ski too. Very clean inside.

[@tdgmtx]

hi mate is the oil adjustment made with the butterfly's in the fully closed position or after the idle is set?

[@2-smoke]

1) put butterfly in closed position 2) attach the carb linkage and adjust if you have to… now the carbs are syncd 3) turn idle screw in about two turns in from contacting the lever… this is a good starting point. 4) attach throttle cable and set your throttle slack 5) attach oil pump cable, align the notches 6) with a warm engine, preferably dipped in water on the trailer, make your final idle adjustment… rpm 1500 in water, 3k on trailer 7) go back and make your final throttle slack adjustment… no more than 1/16” play 8) followed by making your final oil pump asjustment. For most engines except the 951, you will use the jam nuts on the triangular bracket for your oil pump adjustments.

[@Factory928AC]

Where did you get the yellow oils lines from and that mirror!? You make this look to easy. I can feel Fiberglass on my forearm already

[@2-smoke]

The mirror you can get at an auto parts store or harbor freight. The lines are Oregon 3/32” inner diameter. You can find it on Amazon.

[@LiLSweat54177]

Quick question mine has a dot and a line which one do I set it at