SEADOO RXTX 300 DOO IT YOURSELF SERIES 1 JETPUMP

[@federicoabramzon9978]

Best video i found for this job.. straight to the point... Quick and easy to follow.

[@JonBondurant]

Thanks for the great video. I used a soldering iron to burn a gap for wear ring removal.

[@doocrew2438]

Thanks

[@hardwareful]

definitely smarter than the "grind but don't grind too deep" approach. That's how it should be done.

[@Sea-Doopilot]

Turn your steering all the way to the left when disconnecting the steering cable. This will allow a deep well socket to fit on the bolt 👍

[@kkutube1972]

I don't have a sea doo but I do like your informative video.

[@wolfsgor]

Thanks from Brasil, i did no mistakes Best video

[@scottlaulette5269]

Add anti seize or blue lock tight to all bolts when going back together? Ever think about hitting the anodes while you were there?

[@doocrew2438]

ski was brand new anodes were good, they should be inspected but the often wear very slow.

[@PhoneBoothLivin]

Do u have link to purchase rebuild kit for 2019 rxt ?

[@Andrew-mr2dw]

Do you replace any bolts with new ones. I read in the repair manual to replace some bolts

[@dannyvieracarrero793]

Thank you for the video brother. Good info.

[@doocrew2438]

Thanks

[@kayondofrancisrouk8674]

Thaxxs 4 the work you a doing

[@derekpetrongolo5295]

Just to clairify, the Jet pump lube is just to pack that hub with grease?

[@danielsdaringchronicles7821]

Thanks I thought was gonna need a table clamp.

[@Nameless_rat]

Valid tips, I had a nice hydraulic press at work and just press fit the new wear ring in without removing the impeller, didnt damage either and made it alot faster. Actually used a brake rotor so it could fit over the impeller but press in the wear ring LOL

[@TACTICALGRASSHOPPER]

Good video thank you!

[@doocrew2438]

Thanks

[@Andrew-mr2dw]

Where your other wear ring video

[@stevenfox3465]

I see that you did not show how you took the impeller boot off (black rubberized boot)… cus there’s no way you can just tilt up the whole jet pump onto the ground and remove the Venturi with the impeller boot still sticking out the back

[@doocrew2438]

the boot was on the shaft, even though i put locktight on the boots keep coming off on the 21 and 22 models.

[@walkthroughskitty]

Impeller tool in a vice and use an impact gun to get the impeller out, makes your life easier

[@doocrew2438]

i broke my vice (harbor freight) LOL

[@nikkojones2784]

​@@doocrew2438 There on special again next week 😂

[@lxddci]

You mixed a lot of videos One time it's stock impeller after that it's performance one ....

[@Ert604]

Don’t know why you have to have the annoying music

[@pete8016]

Seriously I had to give up on the video!! Completely ruins it