Seadoo xpdi project

Picking up a 2003 XPDI SEADOO and taking it apart.

[@testboga5991]

Awesome video, as usual! You already helped me so much with your content! I have an old rx di and the shop refuses to work on it.

[@SeadooRefurb]

Yes..The dealers wont work on them. I have helped out a ton of people this summer get back on the water. :)

[@infamoussgarage]

excellent vidoes, i just picked one of these up cheap and it runs. ive tested compression and plan to change the plugs, oil, and gas before i water test it. seems to run very well on the hose. any other things i should check? i do havea. flashing maint light any ideas what it could be?

[@SeadooRefurb]

Flashing maintenance light can be a multiple of things including low oil. If not low oil then check all connections . Disconnected temp sensors or air sensors will cause light as well.

[@infamoussgarage]

What rpm should these be getting. Got mine running quite well but it maxes out at 6k rpm.

[@SeadooRefurb]

6800. Sounds like rave valves are not opening up .

[@infamoussgarage]

@@SeadooRefurb thanks can the candoo software test the rave valves ?

[@SeadooRefurb]

@@infamoussgarage They can confirm that the rave solenoid is activating. You can also remove the black caps and confirm that the springs are in there and you can try to move the valves up and down to confirm they are not seized. You can also unplug the solenoid and apply 12volts to it to see if it clicks.

[@lameandboard]

I gotta fix my xpdi that was in a car accident

[@SeadooRefurb]

Car accident..Sounds like a major repair. Awesome winter project.

[@addielb8086]

I am about to lose my mind I can't figure my ski out, it is a 2002 Seadoo GTX DI after tons of issues I finally got it one day at the lake and the next time I went out it would not run, starts fine on trailer idles perfectly as well in water but in water when you run at full throttle it shuts off completely and can't restart it untill a few seconds later. if I try restarting it right away the engine won't spin. I'm thinking rectifier because I got a maint light for a few seconds but it went away when I checked on my Candoo Pro the top two codes were very high voltage. Also, Spark plugs Keep getting dry-fouled. If anyone has a clue about what's wrong, please let me know, I would appreciate it for my sanity.

[@SeadooRefurb]

Try unplugging the rectifier and going for a rip . That will tell u if it is bad. Make sure the batter is charged.

[@addielb8086]

@@SeadooRefurbmy fuel pressure is not holding at 27 psi when lanyard is installed and I can feel fuel being returned through the return lines, Did my Fuel Pressure Regulator Go Bad?

[@SeadooRefurb]

@@addielb8086 Best guess is the check valve in your fuel pump went bad.