"Secret MODE" for the RC ERA C189 Hughes MD500 Helicopter

Рет қаралды 25,505

Andrej Sturm

Күн бұрын

Пікірлер

@aureliusprimus 9 ай бұрын

Thanks a lot but I don’t see how you saved the trims at 1:50 😊

@AndrejSturm 9 ай бұрын

Indeed I could be more clear. To save the settings you have to push and hold the throttle “collective” trim down until the red light stops blinking - stays solid red.

@aureliusprimus 9 ай бұрын

@@AndrejSturm Thanks a lot my friend 😊

@ToyManFlyer1100 8 ай бұрын

@@AndrejSturm... See, this is the kinda stuff that falls in the class..."You don't know what you don't know, but it would be nice if you did"...Like buying Microsoft or Amazon stock when they were IPO's....Nobody, I mean Nobody on KZbin or even the Instruction book mentions this lil tip...Thanks dude, Thanks...Don't have the heli yet, but still nice to know...👍👍😊😊

@0UTCAST247 6 ай бұрын

Tried this with the TX for my C129v2 and it worked, didn't need it but it worked (probably work for other models) . FYI

@peteheymes259 9 ай бұрын

Andrej, I fly since 30 Years "mode-1" therefore I switched this Transmitter to mode1 too. I was anxious tho use your hint / trick on a Throttle right TX. I tried and it worked well! BUT: some has to use the RIGHT vertical trimbutton....

@herrcedes3775 4 ай бұрын

Ich habe nicht richtig gesehen, wie gespeichert wird. Danke für eure Antworten. 😊

@LICobra 9 ай бұрын

Thanks Andrej..I programmed both of my 500's after watching your video.

@goldslinger 2 ай бұрын

If u use the transmitter with another heli, it won’t matter, right? Because the settings are saved in the heli and not the radio?

@AndrejSturm Ай бұрын

You are correct.

@aoelover 6 ай бұрын

Thanks!. I will try this to my RC Eras c159 and c186....maybe works too!.

@jeffkraus1457 4 ай бұрын

Andrej, will I lose them if the radio and or the Heli batteries are removed?

@AirDOGGe 6 ай бұрын

Good video. Saved for later reference.

@peteheymes259 9 ай бұрын

Thank You AGAIN, Andrej; what an accomplishment❤

@eagleonefoxtwo2487 5 ай бұрын

How did you find that out😅very nice!

@53Whiteeagle8 7 ай бұрын

Thanks for the video, can we put the remote control in mode 1

@marc9164 9 ай бұрын

Excellent feature, thank you so much for sharing

@AndrejSturm 9 ай бұрын

Very welcome

@marc9164 9 ай бұрын

I am so jealous of your tail motor mod. I’m exhausted looking for parts to do the same.

@RandyCrickWatercolors 9 ай бұрын

Good job.Thank you Mr Sturm.Great heli

@AndrejSturm 9 ай бұрын

Thank you too!

@TMB5BER 9 ай бұрын

That will be incredibly useful 👍 Thanks Andrej

@silverman6019 Ай бұрын

like your tx16 radio if I put the External Module on do I have to upgrade software or will it be ok to use it the way it is

@BrianPhillipsRC 9 ай бұрын

Nice! Thanks ;)

@QualifiedToys 5 ай бұрын

Thanks very much

@AndrejSturm 5 ай бұрын

You are welcome

@AlexisVILLEMAGNE 9 ай бұрын

Nice tips ! Thank you!

@AndrejSturm 9 ай бұрын

No problem!

@P222RL 5 ай бұрын

Can we change to mode 1 ? Thank you

@martinpoon14 5 ай бұрын

Yes

@TMB5BER 9 ай бұрын

Can you experiment with adding green and red Led nav lights?

@AndrejSturm 9 ай бұрын

Maybe I will …

@pithaksmanratanastien3493 6 ай бұрын

Thank you 🙏

@Mikeylikesit1968 3 ай бұрын

Thats not what down trim does, its for turning off and on optical flow. Has nothing to do with setting trims. When you turned it off and on , you were in optical flow.

@aaronthiele7515 Ай бұрын

Not all RC Era models, even if the same type have optical flow. If it isn't equipped with optical flow this locks it in steady hover.

@skywalkerEA 2 ай бұрын

Hi, do you know how to reset to factory settings?

@Tobi-82 2 ай бұрын

it will do a long Beep in the middle neutral or factory setting.

@tacticalshenanigans2829 2 ай бұрын

@@Tobi-82what? That doesn’t tell me how to reset it

@zoridor16 7 ай бұрын

wonderful I liked it a lot! Do you think it is possible to install a flysky receiver and control? Is it possible to install a higher quality esc? I'm a little suspicious of the quality of the stock electronics... thanks for sharing

@AndrejSturm 7 ай бұрын

Hi. It is not possible to use a different receiver in this helicopter unfortunately. The stock ESC works just fine, it's just the flight controller that has some issues on some of these helicopters.

@jmmvangoor 9 ай бұрын

Dank u broeder Wim voor de duidelijke uitleg,in de naam van Jezus Christus.

@MrHeliwong 9 ай бұрын

Many thanks.

@ret737 3 ай бұрын

Why does my heli get a mind of its own and takes off immediately to the right and smashes itself into the ground? I think it hates me😢

@ronaldcobbs5260 9 ай бұрын

Does this stop the flyaways this Heli does? Mine flew away twice so I don’t fly it anymore

@AndrejSturm 9 ай бұрын

Honestly I don't know. But mine now flies well, no matter which controller I use ... I've had a flyaway issue on my first flight but never again since then, I hope it stays this way.

@doublediamondrailroad5949 7 ай бұрын

So are you happy with this Heli now? I so want to order one. Actually I did order one and Cancelled after seeing several Fly-Away and Takeoff Rocket Launch reports and videos. 😮

@jonspikes4935 9 ай бұрын

Recalibrating it works just as well to

@AerialRCFun 9 ай бұрын

I think maybe recalibrating is done to give helicopter a baseline reference to "level", and then you fly and trim from there but then if you save the trims and go to recalibrate before next flight you will have to retrim because each time you recal it resets to baseline which will usually need considerable trimming from there but if you save like in the video then you should not need to recal before next flights unless maybe you crash and jar it enought to need to recal.

@bradyates7046 9 ай бұрын

I notice you didnt hit you take off button . you pulled down on you sticks down away and then it troddled up and push on the left stick. mine you have to hit the take off button . why did your work that way?