Seismic audio - Sala 210 line array system Test

[@silasmathenymusic]

Can we get a video with a full band setup, or at least guitar and vocals please ?

[@sir0623]

I have 16 tops and four of the SLA subs and when flown with a full power station they are actually incredible because the vocals seem to be alive no matter how far you go back. I have about 4000 watts per 4 cabinets and 1600 watts on the flown subs EACH. I run full rig with 16 tops 4 flown subs and 8 srx jbl subs and DAUM!

[@thedreamentertainment2963]

Wow 8 per side would definitely kill any room You must be doing very huge shows

[@sir0623]

@@thedreamentertainment2963 that rig is for major festivals and LARGE concerts. I’ve done 35,000 people with that rig and super clear and super clean with Major headroom left.

[@RahulPatel-tn4te]

@@thedreamentertainment2963 Song name

[@THEREALDJREDD]

Do you still have that rig?

[@THEREALDJREDD]

Do you still have the seismic line arrays? How are they holding up?

[@blackwolfjr1909]

I got a question why are you using two amplifiers to run them what's the power level cuz not trying to be funny you ask you can run a crown 5000 or amp Mexican numb numbers I mean you have to run the boxing biamp but almost drivers can be pushed of one amplifier I'm just curious on how you got to set up

[@thedreamentertainment2963]

If am understanding your question reason for 2 amps is because the boxes are bi-amp For testing purposes in this video I used 1- Seismic audio Magnitude 3600 - providing signal to the midrange speakers (2 cabinets only) 2. Magnitude 3600 - signal to midrange speakers (2 more cabinets) 3. Qsc amp running 2 cabinets per channel for the high frequency drivers. Theses cabinets run at 16 ohms meaning they are more power hungry so I only chose to down ohm the amps down to 8 ohms bridge . You would need a very powerful amp to be able to run all of them in one amp per side I was not trying to spend too too much on amps

[@RahulPatel-tn4te]

Song name

[@blackwolfjr1909]

You running them by amp or full range

[@whoizdjtopcatanywae_9-9]

NIIIIIIICE!!!!

[@jessecoonen7805]

What amp are you pairing with those?

[@thedreamentertainment2963]

Am actually using seismic audio magnitude 3600 amps. I was on a budget and these amps just fit the bill

[@jessecoonen7805]

@@thedreamentertainment2963 thoughts on them? Audio quality? Is the power truly there?

[@thedreamentertainment2963]

@@jessecoonen7805 they are abit power hungry but they definitely put out a descent amount of power. They are also stable at 2ohms I have literally pushed 4 dual 18s with one amp but had to use a 30 amp circuit

[@jessecoonen7805]

So 4 amps driving 8 of the SALA boxes with two boxes per amp?

[@thedreamentertainment2963]

@@jessecoonen7805 yes sir. Amps have been bridged to put our max watts at 8OHMs Each cabinet is running at 16 ohms