Sense Combi Pure Operating Instruction

Demonstrating how to operate Tylo Sense Combi Pure Control

[@Shootee3]

Hi Mike, I am in the process of installing my Saunafin kit. It is better to have the combi elite controls inside the sauna or outside the sauna? What do other subscribers to this KZbin channel think? Thank you.

[@konstantinloukine5839]

I noticed recently that "1", "6" and "delay start" LEDs are dimly lit on the Tylo Pure Control panel. They are always "on" no matter what function is being chosen or operated. The sauna seem to work normally but may be there is a problem? How to switch off these lights? I tried to switch it on and off at the breaker but this did not help. The sauna was installed about 9 months ago. Please help!

[@JohnDoe-lx5rm]

How does the controller hook up to the wall?

[@soskinrealtydreamhouse6370]

Good evening, I just installed the heater. What is the best place to put a sensor or can I even hide it for optimal temperature. I was recommended 3 inch from heater and 12 inch from ceiling but its not getting very hot.

[@mikewynn4017]

Sensor should be located 3" from heater (not in corner) and 1" down from ceiling. Please contact the office to review your installation and temperatures

[@johnburke4975]

Hi I’ve a steam room in a gym installed and I’m wondering if you would know how to turn it on and leave it on for at least 12 hours a day with it turning itself off I can’t find that anywhere in the manual. I’d essentially like to turn it on set the temperature and turn it off when I like do you think this is possible? And help would be much appreciated

[@mikewynn4017]

Please contact me directly at www.saunafin.com. Let me know make and model no.

[@tobiaskindberg9804]

Would you be able to put humidity at 10 and temperature at 10? Would the oven just go high temperature and steam or shift between the two?

[@saunafinsaunasteam3030]

Tobias, yes you can set both sauna and steam to 10. In that mode, heat is prioritized. Sauna will heat and once it reaches max. temperature, the steam will commence. first to around heat and humidity (steam) settings are balanced. The added humidity makes the sauna "feel" much hotter. Keep in mind, you can also splash water on the rocks to create a momentary humidity spike. My personal preference is the "Soft Sauna"- heat set to 5 and steam set to 10. Steam commences immediately and sauna heats to about 65c(150f).

[@tobiaskindberg9804]

Saunafin Sauna & Steam thanks, so the smartest move is to set steam to 10 and heat to ~5? If you wanted a heated yet steamy sauna?

[@saunafinsaunasteam3030]

@@tobiaskindberg9804 Once you have the sauna, you can play around and find the settings you like. I would set steam to '10' and heat '1' to start. You can always increase temperature later.

[@elliotwahlstrom7156]

The on/of icon starts blinking red after ten minutes even though I put the timer at 6 is there any solution to this?

[@elliotwahlstrom7156]

I’m at a hotel so I don’t know if there is any restrictions