wait, what? this shows a new cable connector going into the new box, then when the panels are being put back on, a ribbon cable is coming up out of the back and plugged into the new controller! What gives???? There was no ribbon connecter in my package and there's nowhere to plug one into either the controller or the new interface module that I just painstakingly installed following the exact instructions on this video. Is this stove going to erupt into flames AGAIN, which is the reason I'm having to install a new interface module in the first place????? Is this video a fake?????
@davidyummus6259 Жыл бұрын
What is the purpose of the New controller & isit supplied free if the Stove is under Warranty ?
@redveiner9 ай бұрын
My guess, as I have a new 2023 CS. Different graphics on the screen and ability to have the stove shut down at a certain temp and then automatically reignite when the temp drops below a set temp. This feature is only recommended for small areas which would get too hot while remaining on a low fan #1 setting as the igniter life is shortened This is the only difference from my old CS stove, so far.
@davidyummus62599 ай бұрын
@@redveiner Yeah, if the outside temp is down around 30F I need to turn my Serenity off around lunch time or a bit later because it's too hot & I don't run it over night so my Igniter is working twice per day,... Don't know how long it will last. I think my unit sat in the box but out in weather because the Bearings seem rusty,... Already replaced the bottom Auger Bearing before the first season was over & now I think the top one is going.