Set PLC IP address with BOOTP

A walkthrough of how to set the IP address of a PLC with BOOTP

[@kojoalmighty]

Thanks very much! I had the exact problem you had and couldn't figure it out. Very helpful!

[@shahriarshajib541]

How will I create communicate between my laptop & my SLC 5/05? Here is the scenario in my case: 1. When I connected ethernet with the SLC, signal LED of the module turned ON, but no device found in latest version of RSlinx. 2. IP address of the module is unknown. 3. I have used BOOT DHCP tool ( Version 3.05 )of rockwell using different subnet mask, while there was no any sign of Mac address of my SLC. However it showed only Mac address of my ethernet adapter whenever I connected ethernet cable to my module. 4. I have tried using both automatic & manual IP address from IP4 configuration of my ethernet adapter properties. 5. I have used one crossover cable between my laptop & module. No switch or router in between.

[@brianwesterhof1863]

speak up can't hear you nearly at all