PLC Programming Fundamentals - How To Use BOOTP / DHCP Tool Set An IP Address Of a New Rockwell PLC

[@arrond316]

Very well put together! Love the easy to understand steps to follow along to.

[@tonysmith3620]

Great videos you have helped me get so much clarity on so many things

[@adriansilaghi6058]

mad respect! my issue was that I was using a docking station (because I do not have an ethernet port on my lenovo yoga just usb ports) I was able to connect using a rs232 cable and add an IP address. I was unable to use the bootp tool because it would not find my mac address due to the docking station ( it found the docking stations mac address) So after adding an IP address I can now connect using ethernet! Thanks Vlad!

[@tektonelec4695]

Thanks Vlad this video helped me with what I was working on today!

[@sakyiyaw3793]

Thanks for sharing your knowledge. Very helpful

[@aurum3404]

Thank you for this!!!!

[@automationguy5600]

Plz sir keep on uploading Videos.... I will support you... And Share

[@SolisPLC]

Appreciate it. I will keep uploading more videos.

[@victorv2678]

Just want add, if anyone has had an issue using the Reltek Family interface for setting IPs its most likely due to your firewall being on. I recently had this issue where no Mac address were popping up using Bootp. Hopefully this helps someone out there 👍

[@rufushughes5602]

I like your presentation but there is there anyway you can slow these presentation down?

[@tonysmith3620]

I have found out that if it does not disable bootp with the button you were pressing you can go to the tool tab at the top if the bootp pop up and disable it there then in the bottom left side of the box it will tell you that bootp has been disabled I don't know why its like that

[@shahriarshajib541]

How will I create communicate between my laptop & my SLC 5/05? Here is the scenario in my case: 1. When I connected ethernet with the SLC, signal LED of the module turned ON, but no device found in latest version of RSlinx. 2. IP address of the module is unknown. 3. I have used BOOT DHCP tool ( Version 3.05 )of rockwell using different subnet mask, while there was no any sign of Mac address of my SLC. However it showed only Mac address of my ethernet adapter whenever I connected ethernet cable to my module. 4. I have tried using both automatic & manual IP address from IP4 configuration of my ethernet adapter properties. 5. I have used one crossover cable between my laptop & module. No switch or router in between.

[@aurum3404]

Got a micrologix 1100 and the only thing active is http server and loses the ip every time its turned off for some reason

[@SolisPLC]

You need to check 2 things: 1, The BOOTP must be disabled after you set the IP. Connect to the PLC and disable it in the settings. 2. The ML1100 PLC Requires a battery to keep the settings including the IP when powered down. Make sure that the battery is fully operational; replace if needed.

[@MJT-DA]

It keeps saying 192.168.1.18, Unrecognized device. What do I do? I did all the steps correct. I'm on rslinx clssic and I had to configure my driver manually it just won't recognize my 1100 series B PLC.

[@SolisPLC]

You may not have the EDS file required for the device. You'll need to find where to download that, import it into RSLinx and it should display then.

[@MJT-DA]

@@SolisPLC where do I download this eds file?

[@SolisPLC]

@@MJT-DA Through the Rockwell download Centre: compatibility.rockwellautomation.com/Pages/home.aspx

[@marcinn6312]

LoL, explaining PLCs in the meantime? Ultima online on your taskbar ;)

[@SolisPLC]

Very few know!