Рет қаралды 7,072
Adjusting the Vertical Cut on my Makita mitre saw.
It's been a long time coming, I have had this question many times about the vertical cut adjustment. However, I never needed to adjust the vertical cut on any of my Makita mitre saws until now.
I bought a job lot of tools, included with those was the smallest Makita mitre saw. The vertical cut was out of plumb by at least 2 degrees. It's an easy adjustment, but in the video I go over the stages to eliminate the problem.
The mitre saw bed was out of alignment also, but with a good clean up and some rust removal everything was back to almost new condition.
The Makita mitre saws maybe more expensive than other brands, but the attention to detail and accuracy is really exceptional.
I had thought I would repair this old Makita and sell it or give it away, however, once I had it up and running I realised just what a great piece of kit these little Makita mitre saws are. Lightweight, easy to set up in a small area and accurate, what more could one ask for.
Many thanks for supporting my channel.
I hope you enjoy the video
All the best
Matt