SGS 12 Ton Hydraulic Shop Press (Volvo V50 Wheel Bearing)

Created with Movavi Video Editor
www.movavi.com...

[@monkeyking-self-proclaimed7050]

Finally a great video that shows what it can do. Too many stupid review videos showing nothing.

[@deuceelec]

Thank you for taking time to leave your kind comments.

[@Megalocade]

I've got got the same press and its great for wheel bearings dont use it that often but its a life saver when i do need it, i originally bought it to do a bearing on a drive shaft thats pressed onto the middle of the shaft and needed the extra head room this press has to put the whole shaft in to remove this type of awkward bearing, did the job in no time, i also have a small 6ton press i use just for bushes.

[@canuckfixit7722]

With the "breakaway" force of just over 6T, this video clearly demonstrates that you need a 12T press for replacing bearings on front drive vehicles. Installing the bearings can be done with a 6T press since all the surfaces will be clean and lubricated.

[@TheUltimate65]

Its not all time this go easy, somtimes the axle rusted in the spline into the bearing , But you was lykey then...👍👍👍

[@stevenparry1448]

What size blocks and right angle steel plate did yoy use?