And I say this, EDGE PRO is the best when it comes to this. I'm from Ghana, West Africa and I follow you a lot.
@thomaschetney990 Жыл бұрын
Excellent vid., on helping a struggling blade sharpener! Because I can’t get these sharp!!! I sharpen knife blades beautifully and many more returning Customers as well as sharpening Scissors. Again Thank You very Much for your expertise
@lyonsharpeningservice28962 жыл бұрын
Great video thank you for the information.
@pichieandboy78162 жыл бұрын
Keep enlightening us.
@sharpenrightservicesllc4 жыл бұрын
Very helpful.
@jamiejohnson99355 жыл бұрын
Nice one, Brandon!
@BonikaShears5 жыл бұрын
Good video. Why do the trimmer blades scoot out from undrtneith the magnet sometimes?
@TheEdgePro5 жыл бұрын
If you are using the rare earth magnets or hard drive magnet they make a single, focused point of contact to the blade versus being spread out to prevent the twist. To prevent that, first I check that I am using light pressure and af it persists I will hold the magnet at the bottom with my thumb and middle finger so that they are touching the blade. usually that stabilizes them enough to not twist.
@caldonsharpening96433 жыл бұрын
I was holding the Mag too far back this whole time! Thanks for the Video. Do you have a video about the placement of the comb or cutter on the wheel when grinding in relation to the center line.
@pichieandboy78162 жыл бұрын
I ask, can any steel with a very flat surface be used as a rub block please ?
@behroozkhodadadi14492 жыл бұрын
Thanks for your wonderful videos. What's the name of block you use after sharpening the blade? I mean what kinda material is that?
@TheEdgePro2 жыл бұрын
It's called a rub block! It is made from steel.
@pichieandboy78162 жыл бұрын
Can any steel with a very flat surface be used as a rub block ?
@Greatness122 Жыл бұрын
You make my business so easy. You have no clue what your doing
@zekewhite67942 жыл бұрын
Which side of the Andis trimmer Comb blade do you sharpen
@TheEdgePro2 жыл бұрын
Hi Zeke! You would sharpen the back side, or flat side of it that the cutters rubs against. Hope that helps!
@cheechengchow91223 жыл бұрын
Hi , may i know where can i buy the red u shape magnet ? Thank you
@TheEdgePro3 жыл бұрын
Hi! Here is a link to our site where the magnet is listed: www.theedgepro.com/products/small-magnet-r
@gilbertpena3426 Жыл бұрын
I also want to thank you, I also was holding it wrong,
@sharpone405 жыл бұрын
I hate the red POS magnets. I liked the clips Andis used but Vicsco had the very best. Ace Sharpening in KC MO has great one that is better than Vic's.