I bought and installed the knockout punch primer for my MEC 9000. It made a difference in my reloading. It works exactly the way Rudy is describing. The wad goes in a lot faster and easier. I also bought the 12ga trimmer that he sells. The finished crimp is more consistent and factory looking. I liked it so much that I bought a puncher for my MEC 600 JR. V. Highly recommend his products and his customer service is superb.
@jamesparlane92894 жыл бұрын
it's not resizing the brass bottom now.
@terryblenkinsop832911 ай бұрын
Thanks great solution
@ThatPNWGuy20244 жыл бұрын
Isn’t that what stage two does in addition to re-priming? I’ve never had an issue with 4-5-6 times fired STS shells
@jaysongrimes90328 ай бұрын
Very nice
@ivanl11548 ай бұрын
Had the swagger be replaced by the current ultimate primer punch?
@curtisdowling37735 жыл бұрын
A close up would be great !!
@robertpagel89517 жыл бұрын
same here, sent a email request at your website. I primarily use an older 600 and would love to have one.
@user-yk4mp2qf9m4 жыл бұрын
Я незнаю английский,но мужик рассказывает предельно понятно.Спасибо!
@Journey4SureKnowledge-N-Wisdom7 жыл бұрын
Thanks for the video! I recently bought 2 Mec 600 Reloaders...one set up to do 20ga and the other to do 12ga. I got the same problem with my hulls needing to be resized because of the indentation around the neck. I went to your website to check on the swaging die and seen where it's listed as 12gauge Ultimate KnockOUT and costs is 24.95 but when I click on it, it says out of stock.
@a8rcdave2 жыл бұрын
You showed a Remington shell which is a tapered shell. Vs. A federal shell which is a straight wall shell. You need a different wad for each. The wad needs to be tight to the shell so the powder burn gasses can't escape around the wad.. a must for consistent patterns. Also ,, the first stage die can be adjusted lower to travel lower into the Hull. In short, , do not modify your hulls. . Watch a video on the different types of hulls and wads first.
@CreativeReloadingSolutions2 жыл бұрын
Hello, I understand that - the video was done for demonstrational purposes only.
@TrajanowskiRifleworx3573 жыл бұрын
I need the whole resizer die and can't find it as a whole part. Mec sells it as multiple parts and the cost is a bit too much if you add them all (about $55). Is there anywhere else to buy the sizer for a lower price (with international shipping)?