Shower glass door sweep replacement

[@RedPanda79]

Love how older how-to videos get right to the point. They are perfect

[@LegacyHandyman]

Thank you . Comments like this keep me motivated

[@myparadiseing]

Public service announcement: run the sweep under hot water for a couple of minutes as this will soften the plastic and help with fine-trimming and fitting it under the door. Cleaning the shower glass before installing the sweep is also important.

[@bobbyGnOly]

after watching several other videos, and wasting a lot of time...I found this great video that is simple and right to the point... Thanks

[@tressahill350]

THANK YOU! I had no idea I could pop that off and clean it - you have no idea how happy this makes me. Thank you, thank you, thank you!

[@LegacyHandyman]

You welcome. Please don't forget to subscribe

[@romysketches7373]

Thank you so much for this video!! I was definitely holding my breath when you were using the saw and then the knife, lol!!

[@LegacyHandyman]

You are welcome. Thank you for your comment

[@fraxhead]

Short and sweet! Thank you! I was replacing mine, and realized I forgot which way to install the replacement. 😀

[@Isabel-of4wq]

Very helpful video on how to take off and put on - recommend you don’t rush off to buy one (and potentially get the size wrong) I found mine was in great condition, but just harboring some seriously yucky dirt. I took it off and cleaned it with shower cleaner spray and put it back - tada!

[@LegacyHandyman]

Great tip!

[@MiltonBatman612]

Great tip on rounding the edges! Thank you

[@xzivizx]

Whoa dude, you got a razer and your cutting to your thumb.. that's Beast mode!

[@PetrucchoB]

Good job rounding those corners. Like!

[@marcdobin]

Thank you for this. It seemed simple enough to do, but a couple of your tips were very helpful.

[@LegacyHandyman]

thank you for your comment

[@diamond6256]

I love this video, fixing to do mine. I am also adding a bead inside/outside the door to seal the open of the piece so mildew does not get in. Texas girl tip

[@ideaman99]

Thanks for the post. The doors swings out from left to right and meets a glass panel when closed. The leak is at right end of the door against the glass panel The "over flap" on the seal needs to go a little past the door glass.

[@ChillerKane]

Thank you for this video. I have to do this and im stressing. This shower door is the same as mine, so I will give her a go. Thanks again . Appreciate you taking the time.

[@anyacara9538]

How did it go?

[@ChillerKane]

@@anyacara9538 Perfect. I had no idea it was going to be that easy. Thanks again

[@rosemarymay3914]

Wish I had seen a video before struggling to replace my curved shower door seal. Secateurs worked great to cut it

[@JoyahS82]

Thanks!! Learned a lot in just a short vid!! Thanks for the links as well

[@fopguy41]

i installed the new sweep. new sweep stays on the door fine, but now my door won't close. i think the problem is that I barely have a gap between the bottom of the door and the floor. and from looking at your video, you have a little bit of a gap, so that the bottom sweep can fit right in. do you have any tips?

[@ghazelrashid3522]

Were you able to install with minimum gap? I am having the same problem.

[@colincassidy2861]

Great video, simply explained rubber mallet was great tip, thank you👍

[@wclapham67]

He made it looks so easy whereas I struggled to put it on. Kept coming off when I tried to put the whole thing onto the glass door.

[@LegacyHandyman]

You probably have wrong size sweep . It should be easy.

[@wclapham67]

Legacy Handyman yes, you are right that I had the wrong size! ;-)

[@rosemarymay3914]

Yes I had to try 2 different brands

[@westcoastkitties]

Omg!!! THANK YOU, THANK YOU!!!! I can do it myself now. Running to a hardware store. Mine is not used, my cat pealed off the silicone. Little punk 😄

[@camaroman4070]

Does deflectors go inside towards shower?

[@Kelspeed1972]

Great video but their was a gap. 2 in fact- those two grout lines. My OCD would have me build up those two areas with some clear silicone to get them gap-free with the sweep.

[@inthemiddle-tanyalynch5904]

I replaced mine but the lip isn't allowing it to close. It is catching in the middle but it us on tight.

[@LegacyHandyman]

try to find different sweep model or trim it in the bottom

[@tanyale2331]

Great video - straight to the point!

[@dancingspaceman9963]

Do you know what I could use if I have a sliding door? Because water is filtering on the bottom of the sliding door...

[@kenkev1935]

I'm glad u did this video sir....it was very helpful. Thank you.

[@elirodriguez0]

Excellent tutorial. Thank you for sharing!

[@LegacyHandyman]

Thank you for your comment

[@Kill_OrB_eats]

"My man!" *Denzel voice *

[@francoisj.interiors2090]

Thank you for the info Can I hier you to change mine?

[@sydneym1873]

Your the best! Love you! ❤️❤️❤️👍👍👍

[@suwanatatnina]

Thank you so much to share with us how to fix my leaking shower door.

[@ironhorsevinnie]

Thank You

[@Glen.Danielsen]

Gracias hermano! 🙏🏽

[@DMM6]

Very helpful. Thank you my friend!

[@hectormancia6597]

GRACIAS AMIGO

[@LegacyHandyman]

You are welcome !

[@lr8308]

Can you keep the link in description part number or link for. Homedepot?

[@LegacyHandyman]

amzn.to/3p4EeOS

[@LegacyHandyman]

It is Amazon link in the description

[@TheSora1326]

Thank you legacy handyman for your service

[@larrynarvaez7545]

Thank you, Legacy Handyman. 😋

[@melodischonken7885]

This was very helpful!! Thanks.

[@MarkMphonoman]

Thanks for the tips, much appreciated. 👍👍👍👍

[@SasJag12]

I would not use the mallet. I have seen doors shatter days later from that process.

[@sgreeni]

I need help with this very thing. It seems HD only has one size of the plastic you used and I have to use something to fill it in. Can you tell me how to get smaller sizes?

[@sgreeni]

Silicone...

[@LegacyHandyman]

@@sgreeni try to find glass place, ask if they have right size . Silicone will look okay for a week then you will be at square one.

[@sgreeni]

I think you are right. The mold/mildew came right back after I cleaned last time. I appreciate you!

[@GG-lc2bv]

Helpful , thank you !

[@LegacyHandyman]

You're welcome!

[@thefoxalexg8752]

How About the sliden glass door 😢

[@LegacyHandyman]

Different system

[@bettyescookingchannel]

Thanks.

[@donutman1958]

mine has a metal sweep i took it off but the new plastic one does not fill the gap. how to move the door down?

[@LegacyHandyman]

Sounds like you need to reinstall metal trim back to the door . Home depot has plastic sweep for framed doors .

[@marknatius2987]

This might be helpful in this video below if you go to the end he talks about a shim spacer that’s what you might need it sounds like from what I understand kzbin.info/www/bejne/qmfVg3mbr7ifhdU

[@MayaRochelleandFamily]

Nice job 👌.

[@alfredbriscoe3321]

Excellent presentation AB

[@clydebear6914]

Cheers dude. Job done here.

[@lolam.9125]

hi, where can I get the clear one?

[@LegacyHandyman]

Go to any glass shop they will sell you one. Or check out link in the description and you can get one on Amazon

[@TomKaszuba]

Thank you very much for this.

[@carolineblechasseur7131]

Thank you so much for this video

[@KittyOfficiallyNotYo]

Thank you. Going to try today 💜

[@pennycooperider6234]

Replaced the sweeper, but door hard to open now. HELP!

[@LegacyHandyman]

You need to seat trim all the way . Or raise door a little bit

[@matthewhyun1313]

how do I temporarily remove the door so I can clean the corner?

[@LegacyHandyman]

I would not recommend that. But if you absolutely have to do it you have to unbolt set screws that are holding bracket on the glass

[@matthewhyun1313]

@@LegacyHandyman I was hoping I could remove just the door without touching the bracket on the wall, just like a regular door.

[@LegacyHandyman]

I don't know if that is possible with those hinges .

[@matthewhyun1313]

@@LegacyHandyman okay Thanks!

[@LegacyHandyman]

@@matthewhyun1313 pleaselet me know if you were able to do it .

[@jontom7787]

Cheers mate, very helpful.

[@LegacyHandyman]

Glad it helped

[@karenturner7184]

Thank you. I now know I can do this. Yeah

[@kennybfrank1829]

I can't find a glass sweep at 5/8" width 😩

[@LegacyHandyman]

Try your local glass shop.

[@kathleensauer3394]

Thank you!!!

[@westcoastkitties]

Omg Thank YOU!!!

[@LegacyHandyman]

thank you for your comment

[@wendyp8488]

Thank you this was very clear ⭐️

[@LegacyHandyman]

Glad it was helpful!

[@AnPham-yl2py]

Where i can buy items

[@MrHondaAcura]

@@AnPham-yl2py i have the same question too

[@hayleywise7403]

​@@AnPham-yl2pyHome Depot, Lowe's or any building supply store.

[@hayleywise7403]

​@@MrHondaAcuraHome Depot, Lowe's or any building supply store.

[@DuyDepTraiPhoBaTrieu]

My shower is leaking there since there is nothing to stopping it from leaking. I will be grabbing a strip soon!

[@AndreaBeltran]

Mine is sealed on 🥺😫

[@elizabethguzman9914]

Thank you you save me. $40.

[@jasonramirez449]

Never use a dead blow or a hammer to put on a door sweep. I’ve been a Glazer for 25 years the weakest point of any temper glass is the corner. I had a customer take a hammer one time she had to go to the hospital with stitches.

[@LegacyHandyman]

What I am using in this video is rubber mallet.

[@SanSan0575]

good！

[@LegacyHandyman]

Right on! thank you for your comment.

[@savimaharaj1963]

I am glad for your advice, but I'm afraid that I was worried for your safety when you were using the hacksaw and craft knife in your lap. I think I would slice my fingers off! I suggest you show beginners like me a safer method.

[@MrSynyster2010]

That looked very difficult. Damn bro, use metal snips or hacksaw to cut that sweep before you cut your damn thumb off.

[@robertedwards3528]

ROBERT TUNNELL dude was barefooted

[@MrSynyster2010]

@@robertedwards3528...I just hope nobody sees him put that sweep on with a mallet and think to themselves... well, I have a hammer... that's good enough.

[@TomandBennewsforNZ01]

👍👍👍👍👍👍🤝🤝🤝🤝🤝🤝

[@edenbondoc5207]

Thank you

[@yd8974]

Thx.

[@LegacyHandyman]

No problem

[@judeeyton123]

Thank you