Sick CVL 630 Training

[@daisycastillo6135]

Hello, Would you happen to know why I’m not picking up a advice when I scan for devices? It’s connected via Ethernet cord to the laptop top. I even modified the settings. Thank you.

[@PLCAutomationTraining]

@@daisycastillo6135 check your PC ip and subnet

[@jatinpachisia4420]

I am facing an issue with configuring my clv65-0120. i am being able to install and configure it. However, the laser does not read the code

[@98specdb8]

After you have set up the scanner as in your video how would you then backup these parameters so that you can keep them for if/when the scanner fails?

[@PLCAutomationTraining]

You should be able to save through the software.

[@marknardi5576]

Hi is it possible that you can have the data coming out of the barcode scanner going to a Compact or ControlLogix PLC over ethernet? If so could you do a video on how that's done.

[@PLCAutomationTraining]

Mark Nardi yes you can I'll put something together for you.

[@charleslester4290]

@@PLCAutomationTraining is this video available?

[@hajrit]

How to configure to read multiple bar codes ?

[@krabimotorpart]

very good

[@christophervenuti119]

Very helpful video. There was one thing in particular that I was looking for that I didn't see you cover, though. When you set the statistic to on, there is a statistic option that pops up in the service folder. I haven't been able to see any read rates generated in that, unfortunately. As I am trying to analyze the performance of older units, that sort of analysis would be helpful. Do you have any insight? Thanks

[@PLCAutomationTraining]

They offer a software that ties to this if I recall correctly

[@scottcochran2371]

If you are working on older units you will likely have to open a terminal screen in CLVMain

[@scottcochran2371]

That's a long-ass code you're reading