siemens simos 2.1 immo off (version 1)

in this video i am showing how to remove imobiliser from a VW Golf 4 1.6 petrol. the ecu is a Siemens Simos 2.1
hope this can help someone.
thanks for watching.

[@moussacoulibaly5667]

Super

[@pauladrian4617]

Its work ! Good job

[@martinflierman2456]

Hello sir , thanks for all your great videos. Do you maybe know on what byte line the immobiliser pincode is stored on this ecu ? And where to find such information.? Thank you very much . I appreciate it !

[@PSICompanyPerformance]

thanks for watching on these ecu i never tried to locate the pin code on the dump, because i always used Abrites to read it via OBD. idont have any ecu like this to try it now but i will post a video on that as soon as i get one here in my shop. good luck

[@maverikwartj0184]

hello i should do immoff on this ecu how do i know if version 1? thanks 5WP4417 06A 906 019 AK Eprom ?or flash?

[@PSICompanyPerformance]

If you do the version 2 it works on all of them...you should only do version 1 if you are sure that your ecu is version 1

[@maverikwartj0184]

@@PSICompanyPerformance thanks for replying, but how do I know if my ecu and version 1o version 2? if version 1 is done immo off on the eprom from what I understand, if instead version two is done on the flash 29f200

[@PSICompanyPerformance]

@@maverikwartj0184 correct version 2 is on the flash... You only now depending on if you have immobox or if immo is on the dash..

[@eduardo4878]

mine has immo on the board , is it version 1 or 2 ??? @@PSICompanyPerformance

[@PSICompanyPerformance]

If you have immo box under dash its version1 if your immo is on the cluster its version2. Good luck and thanks for watching.