SIG Sauer P320 Trigger Removal and Installation

[@jackruby4680]

Clear and concise!

[@Tito_Soto]

This is the result of self training while blindfolded, excellent video! Thank you!

[@jzim6706]

This is fantastic. I am extremely challenged when it comes to anything three dimensional, you wouldn't want me to take out your appendix or do your knee replacement. I watched this video several times and kept playing with it while I worked on my first P320 trigger replacement. It took me 25 minutes for the first one, but then only a minute or two for the second and third triggers I replaced. Bravo, sillejin.

[@gjhoward]

Just installed a new Sig flat trigger. This video was a huuuuuge help in the disassembly and reassembly. Thank you so much!

[@jaycarva]

Thank you for getting right to the point. Saw what I needed to in the first 20sec

[@Leatherminivan]

By far the easiest way I seen!

[@Leonardokite]

The first time I changed that my trigger I did not even remove that spring. I just lifted the trigger bar up and moved it back and swap out the trigger and then jockeyed the trigger bar back into place. Piece a cake! This is basically what you did. Now the second time with the upgraded P320 and the new apex trigger I couldn’t do that somehow or another. Bottom line is that spring went flying off into oblivion LOL. After a good bout of “spring” cleaning I gave up. My new springs yes, springs I bought two, should be here in a couple of hours. Hopefully this time I’ll have better luck. I will also be doing it in the bathroom which does not have a bunch of places to lose a spring. (The drains will be covered) ANYHOW! This time I redid it like before (basically exactly like you did and less than a minute later....bingo! This is definitely the easiest method by far.

[@guitrich]

Holy shit, you made it so easy! I did mine before I saw this video and it took over half an hour, the little spring was hard to get into place.

[@pawngrabber226]

Very nice, the Best trigger removal and installation on KZbin

[@Dsabre1]

Many thanks! you make it look so easy

[@2wEntEe]

Beautiful. Thank you sir! Nice behind the back trick

[@dunkindronuts7131]

Much better than the apex video!! Thank you!!

[@cmlndz09]

Thanks you so much for this is was so easy after watching this.

[@retiredboxingref7620]

This work for the P365?

[@sillejin]

I don't know. I haven't tried it with a P365 yet.

[@roberthaines996]

Well said

[@michaels8179]

what about the sear spring

[@sillejin]

You don't need to mess with the sear spring when removing/installing the trigger/bar.

[@smacc1323]

no matter how easy you made it look, I still cannot put it back together. Your hand is blocking most of the important parts.

[@sillejin]

Which part are you having trouble with? I just had someone who has never handled a firearm watch the video and do it.