Simple TEF6686 DSP AM FM tuner with ESP32 microcontroller

Very good project. Thank you.

[@hassimtony7372]

im planning to build one same like yours..and i found your chanel..nice build

[@MirkoPavleskiMK]

Thanks

[@hassimtony7372]

is it posible to add bfo to this radio

[@MirkoPavleskiMK]

@@hassimtony7372 I don't think it can because it's DSP radio.

[@josesnyder840]

Can you make a tutorial on how you make the boxes?

[@rons1566]

Very nice job. Thank you. THis was very helpful to me.

[@bobby9568]

So cool, just discovered this channel

[@MirkoPavleskiMK]

Thanks

[@mikecarlson6416]

impressive

[@Julio.pu2lwr]

Good evening, I would like to do this project but I've been trying for several days but all the time the src wificonnect library fails among others and I've done everything and I can't record on the Esp32, could you help me, if you can, I'd appreciate it

[@AirchainGuru]

Reception on FM has much disturbance because of the long display cabling, it is advised to place the ESP as close to the display as possible and eliminate the display wiring. I have tried to use some ferrite coils on the display cabling, this helps somewhat but not as much as fitting the ESP together with the display on one board.

[@CBTman99]

I have seen shields placed around display modules to reduce interference.

[@FrozenDoberman]

My TEF6686 desktop 2.0 tuner version was bought from AliExpress, China. With and without a roof-top 8-element 87-108 MHz FM Yagi connected, there is no internally generated display panel noise. Hence, the RF dB noise floor is low. In your TEF6686 video some digital hash noise is present on certain blank frequencies. Is this internally generated TEF6686 display panel RFI noise? The test is to see if the digital hash noise is still present with the antenna wire disconnected from your TEF6686 project tuner.

[@yoppindia]

how was am reception, does it support radio modiale?

[@Vincent-zz4xh]

Cool ❤

[@نشوانالظاهر-م9ف]

❤❤❤

[@avatargzip]

Отлично!!!

[@Sjef_PE5PVB]

Nice video. But you should update to the latest firmware to have much more functions.

[@MirkoPavleskiMK]

Thanks a lot for this wonderful project