Single Mosfet Mini SSTC Tesla coil with 10 + cm Spark

[@Javi_Laraaa]

Hi, nice vídeo. Why when I connect the circuit to a DC source does the circuit short out? I did it with a 36v transformer and it worked fine, but in DC it shorts out.

[@samj1012]

Please add audio modulation. Great channel

[@electronics.unmessed]

Hi Mirko, I am always enjoying your DIY projects very much! Thanks for sharing. I am always wondering about the RF interference of the Tesla coils. Could you elaborate a bit on that, especially in the short wave and UHF range?

[@electrogravlabs]

Please do

[@gerd3136]

Amazing, thank you!

[@PosthumanKindergarten]

you put a pack of cigarettes near the coil for comparison...... how naughty!! :D nice coil!! i love the "mosfet slayer" system, it works very well

[@RAVI171175]

Very good job my friend.. Keep it up.

[@rosypradhan801]

Hey! It a really good project and is actually easy, but can i use a 30v 2amps dc power supply(specifically a laptop charger)?

[@MirkoPavleskiMK]

Yes, but the results will be weaker

[@realityforecast]

Fantastic!

[@Wicak_s]

Amazing❤❤❤

[@Ubaydulla-e6i]

Hi .Can you write circuit .plaese.I am student .I make this tesla coil

[@someguy5971]

Very nice video once again! Although it would have been also interesting if you showed the heat difference using the special thermal camera that you demonstrated in a previous video, but overall very nice!

[@MirkoPavleskiMK]

Nice idea, thanks :)

[@rares2]

Hi, can I use IRFP250 mosfet with ultrafast diode UF5408 for this circuit? Is the voltage DC?

[@MirkoPavleskiMK]

Yes, you can use IRFP250 and UF5408. Voltage is unfiltered DC (pulsating),

[@rares2]

@MirkoPavleskiMK thank you

[@BlazenWinchester]

Build a slightly larger one, making a video of step by step instructions

[@helicopterkin1607]

Can u1560 fast diode be used to replace u1540?

[@MirkoPavleskiMK]

Yes

[@helicopterkin1607]

@@MirkoPavleskiMK What types of capacitors can be used? Is it possible to use polypropylene capacitor or mkph 450v capacitor?

[@MirkoPavleskiMK]

@@helicopterkin1607 I use MKP capacitor

[@helicopterkin1607]

@@MirkoPavleskiMK but in my place I only have cbb22 capacitor and the new electrolytic capacitor is 1uf,400v the rest is not there, can I use it?

[@MirkoPavleskiMK]

@@helicopterkin1607 You can use 1µF/ 400V electrolitic capacitor

[@cisarvialpando7412]

What can I use if don't have that transformer ballast...

[@MirkoPavleskiMK]

You can use primary from 150W standard E-type transformer

[@Mrjjjjjj]

Hi sir, where in mosfet you connected the interruptor?

[@MirkoPavleskiMK]

Between Gate of Mosfet and GND

[@Mrjjjjjj]

​@@MirkoPavleskiMKis there any other change i need to make in tesla coil if i connect interruptor?

[@cisarvialpando7412]

How

[@Wicak_s]

Does the circuit use AC or DC electricity?

[@MirkoPavleskiMK]

It use pulsed DC, one diode + small value capacitor

[@vivekkale5518]

Positive negative connection