SiteVision Introduction

[@penningtoncolin]

Hi Jeff I've set up base station but machine is saying gnss out of tolerance and I've no northing or easting on my work screen what am I doing wrong cheers in advance

[@JeffLarsen-iz8qk]

So the first thing I would check is to make sure your base station is truly broadcasting. If it’s an 855 it should say bounce trans/sync on the face plate. If it’s a R750, the TX on the face plate should be blinking. Then verify the machine is truly connected to the correct channel. Then start checking both base station and machine antenna connections. The light on your machine radio will start blinking when it receives the base. Try that first.

[@rumhave9632]

What does this setup cost?

[@JeffLarsen-iz8qk]

Hello, I am sorry my last response did not post to you the day after you asked this. But you will need to check with your local dealer for sure, but for 1 Trimble’s connection license, the gps receiver, battery and bracket starts about $2,900. You use your own pole and devise like a phone or tablet.