Slingshot Catch Box and Slingshot Ammo Sorter - DIY

OVERVIEW
Made the catch box and ammo sorter using some 2x4s, dog ear pine fence pieces, 1/4 MDF board, 3/4" PVC pipe and some 1/2 EMT conduit pipe that I had laying around.
REASON
I shot different slingshots with different band and pouch setups which don't lend them to all to shooting the three most common types of sling shot ammo I shot (1/2", 3/8" and 1/4"). I used to go around and pick them up with a heavy duty magnet from Harbor Freight (in the back ground you can see a large piece of canvas, that was my previous back stop and then I had a 4 foot by 4 foot catch tray that the ammo fell into. It caught ammo really well, but it was all mixed together. This caused problems when I was reaching into my ammo containers because I was having to sort them on a one by one basis. I needed something a little more automated.
INSPIRATION
►Catch Box: StanCrafted Video: • A DIY Slingshot/Catapu...
►Marble Sorter : Pocket83 : • Marble size sorting ma...
Both the StanCrafted and Pocket83 workmanship is far superior to the work I've done here.
SPECS
►48" tall
►14 1/2" deep
►20 1/2" wide
►Shelf is 12" from the bottom
CUTS
►Legs (four) 48" 2x2's
►Sides frame (four) 11 1/2 2x2s (2 for the base and two for the
►Back/Front frame (three) 17 1/2 2x2s (2 for the base and one for the top)
►Shelf (two) 11x9 1/4 wafer board
►Sides: (two) 32 x 14 1/2 MDF board
►Backstop: (six) 5x20 1/2 pine fence
WHAT I WOULD DO DIFFERENT
-Catch Box
►Depth - I would make it 24 inches deep
►Shelf - I would raise the shelf to 18 inches (to allow for a steeper slop for the ammo sorter)
►Floor - I would not use wafer board and instead use MDF
-Ammo Sorter
►Rods - Would use 3/8 steel rod
►Rods - Use shorter rods with steeper slope
►Rods - Run the ammo sorter behind the catch box instead of underneath

[@mikecollins8241]

Nice, I am building some catch boxes and wanted to add a sorter for ammo, this gives me some new ideas :)

[@StanCrafted]

Great video, Bryon...and a really nice catchbox...I really like the sorter...I agree with you on the depth of the box...if I make another I will extend mine to a minimum or 20"...24 would be even better. Enjoy the shooting!

[@moonolyth]

Well, I think it's a good reference model for us. Yup, the separation tubs would be better made of smooth metal. I worked an industrial separator using this method separating pill-type units within thousands of an inch. Great addition! The back material.. may be better to add 3 or 4 layers separated 1/2in or so to help dampen but probably not that great a difference. Great Idea build may have to copy!! Thanks for sharing !!

[@slingshotGDN]

Good idea. Good video. 👍

[@charlesdang2557]

Awesome video, Byron. Many good ideas there. Appreciate the suggestions for improvements. I am planning one 24" deep. Was concerned it would be too bulky. Your video definitely helped me decide. Thanks for sharing!