SnapMaker 2.0 Filament sensor replacement
Рет қаралды 2,753
Күн бұрын
@86larsonrd 5 ай бұрын
Is a fuse change possible? Is the process similar?
@R-TechEnthusiast 5 ай бұрын
Fuse? There's no fuse in the extruder that I'm aware of.
@marcomonteiro7307 9 ай бұрын
Do you have a blue piece where the filament comes in, where can I buy it?
@R-TechEnthusiast 9 ай бұрын
You will need to 3d print a new mount for the 3dp module, there are quite a few designs on Thingiverse. There's what looks like a silver disk on top of the module with 2 super tiny screws. You'll remove that part and replace it with the 3d printed part. Then you'll need to buy the Pneumatic Fittings (the brass and blue part) as well as a bowden tube for it. The fitting will screw into the part you printed out.
@trevorharned8856 2 жыл бұрын
Where did you purchase the sensor
@R-TechEnthusiast 2 жыл бұрын
Contact snapmaker customer service, you can get it directly from them.
Embrace Making
Рет қаралды 1 М.