Finally! An instructional video that isn't total crap and filler. Concise and easy to understand, well done sir!
@dgriderjw6 жыл бұрын
Great video. And my favorite part was how you moved it along quickly. No wasted bandwidth of you filming your feet or saying "umm" 100 times. Direct and to the point.
@kendallfolsom36717 жыл бұрын
How can I waterproof my Polaris 2011 400Ho?The snorkels are ran up just don't know what vents that I need to run up and what do I dielectric grease?
@Jeff-jr3sg7 жыл бұрын
Kendall Folsom grease all the electronics and connectors
@kendallfolsom36717 жыл бұрын
Honda Powa where would they all be located
@Jeff-jr3sg7 жыл бұрын
look up a wire diagram for your bike and grease all the connectors. you can find most by removing the plastics. look for some plugs put grease in them and put them back together did all mine in about 15min.
@kendallfolsom36717 жыл бұрын
Honda Powa thanks
@brycesanders72997 жыл бұрын
what all do i need to do to snorkel my four wheeler. like air box and what else
@everythingoff-road66377 жыл бұрын
Very cool vid and very helpful for p500 owners
@markbulluck81486 жыл бұрын
Is that ultra black Is that the same stuff made gasket maker
@fio4297 жыл бұрын
nice video! I may do the same to my P5
@treyr41907 жыл бұрын
could you make a diagram of how to make home made portals for a solid axle honda like your old 300 because i want to make some for my honda but dont know where to start
@natelocke93997 жыл бұрын
Are the P5s re-geared at the diff to get the low final ratios? if so can we go even lower using GRs for Rubicon??? Example, could possibly go up to 27 inch tire then add 15% GR to keep the stump pulling ratios.
@MudPuppyOffroad7 жыл бұрын
+Nate Locke depends on the year 2017 is geared highet
@natelocke93997 жыл бұрын
Mud Puppy So we can use re-gear from a Rubi or no?? Or did Honda already do that essentially to achieve the lower ratios
@MudPuppyOffroad7 жыл бұрын
+Nate Locke they all have lower diffs but the 17 has a taller 1st gear for pansies
@MudPuppyOffroad7 жыл бұрын
+Nate Locke Rubicon gr will fit secondarys won't mess up the shifting
@natelocke93997 жыл бұрын
Mud Puppy cool, thanks!
@dillonjohnston10227 жыл бұрын
can you do a video on your take on the gearing between the p500 and a rubicon? i cant find much on the internet.
@dillonjohnston10227 жыл бұрын
Mud Puppy thats what i was thinking. i just bought a p500 and i want to run a 31-33 inch tire. id like some arched a arms to cause the clearance is garbage right now
@MudPuppyOffroad7 жыл бұрын
I can make arched rear arms for them
@dillonjohnston10227 жыл бұрын
how much?
@MudPuppyOffroad7 жыл бұрын
Dillon Johnston 325 adjustable with hiems
@johndutton71917 жыл бұрын
Mud Puppy hey have a big question hope you can help I just got a 300. And randomly when I try to start it it will just click but I watched a video where this guys 300 did the same and all he did and is flip the pressure release and push the kickstart and then the electric stert would work. I did the same thing and it'll crank after doing that. But what is causing me to have to do that sometimes thanks a lot
@anthonycollucci41686 жыл бұрын
I have a 2018 Honda rubicon that I just bought. How much do you charge to snorkel, seal, and dielectric grease the bike? And should I wait for its first service?
@MudPuppyOffroad6 жыл бұрын
That's a really time-consuming job you don't want to pay me to do that LOL let me know when you need a gear reduction though
@MudPuppyOffroad6 жыл бұрын
as far as Dielectric grease we haven't been messing with that lately the only connector I bother doing is the one on the front diff I relocated up higher and grease it a little bit
@anthonycollucci41686 жыл бұрын
I appreciate you getting back to me and for the information. Thank you. Stay safe out there!
@17madracki176 жыл бұрын
let’s see it with the 33”. ive got 28” mayhems on my p500 and thinking bigger is needed. does it clear the frame at the front when steering.
@MudPuppyOffroad6 жыл бұрын
Move the arms forward
@17madracki176 жыл бұрын
Mud Puppy once i get the first 20hr service done. who knows what will happen to it. a video on clutch adjustment would be awesome. just feels off a bit but it also has 2 hrs maybe it’s breaking in.
@jackrigdon63367 жыл бұрын
Mudpuppy if I tighten the clutch on my bike will it help me turn bigger tires
@holdenadams3337 жыл бұрын
Or a can am...😂😂😂 yes straight Honda all the way!!
@corgily4 жыл бұрын
Great video really to the point.
@justinteal4957 жыл бұрын
can you go over how to waterproof a carb atv?
@3006USMC7 жыл бұрын
Kickass a p500... bonus camo!
@jacobnoble93637 жыл бұрын
how big of a zilla can you put on it stock
@ethanvilcan38457 жыл бұрын
nice dude
@dademade_jayy7 жыл бұрын
why don't you put the tractor tires on your Rubicon
@MudPuppyOffroad7 жыл бұрын
Jayden Sikes I have ran several different sets of tractor tires on it
@MudPuppyOffroad7 жыл бұрын
Jayden Sikes there are several videos of each
@deere33215 жыл бұрын
I like the idea of a snorkel just for the simple fact that it will draw cleaner air into the air box. The stock location is prone to a lot of dust in dry conditions. Nice job.
@WBOS727 жыл бұрын
Thank you for this vid. How is the P500 in mud without a front difflock? My polaris will be getting replaced with one. Thanks
@MudPuppyOffroad7 жыл бұрын
WBOS72 it's a little low on gc and travel but it has very low gears
@WBOS727 жыл бұрын
Mud Puppy would you still buy it?
@dirtyhornswoggle18616 жыл бұрын
Mud Puppy would you buy a new p500 or a used 800 or 570 the? Can't really decide and kinda on a budget
@dmwz71317 жыл бұрын
Hey Christian, is there anything that you can do to the rubicons electronics that are above/ at the stock snorkel to seal them off so water wont get into them? I know you had a video saying to air it out every now and then but is there a way to seal it and add a vent line so it would allow the pressure/ air to escape?
@hankoffroad81787 жыл бұрын
he said ....to tow can ams with bahahaha
@shawnholloway10736 жыл бұрын
So is there a video of it with the 33"bkt yet? I am picking up a p500 this Saturday and gonna throw some bkt on it not sure if I'll need a lift or not. It has already been snorkeled but I'm gonna go over it make sure all the vent lines are ran before I take it to Hog waller
@colecardelli68337 жыл бұрын
This dude is obsessed with Honda lol
@Jeff-jr3sg7 жыл бұрын
Cole Cardelli of course no belt no worry.
@Jeff-jr3sg7 жыл бұрын
is that your 500 and how many dogs do you have?
@Jeff-jr3sg7 жыл бұрын
nvm not yours but sick job #Mudpuppyafied
@TheAustinBarber7 жыл бұрын
Do you live in blackshear? I have a 2017 Honda foreman 500 and I have a snorkel kit coming for it. Would you install it and I pay you?
@zachcondon-oz3uh7 жыл бұрын
Honda needs to make a 1000 atv with like 80 horsepower I would buy that very fast
@zachcondon-oz3uh7 жыл бұрын
Parker Stewart I know I would buy it so fast if they did
@brodybraswell87203 жыл бұрын
I know this comment is 3 years old but that would ruin can ams reputation for having alot of power
@aaronleblanc5407 жыл бұрын
so do you think it will be ok to run 27 by 11 mega mayhems on stock clutching on a Polaris 400 h.o? we already have the tires and lift just waiting for rimz
@tomkeating4655 жыл бұрын
Please show people how to take apart electrical connecters on a Honda pioneer 500, it would be useful
@vanessas67097 жыл бұрын
mud puppy would vampires be good on a nondifflock honda
@McFattDaddy08207 жыл бұрын
I know this is random as shit for this video but do you know of any gear reductions for the 2016 Rubicon deluxe model, the white one with the dct transmission? ive found one I want to buy but this is the only question holding me back. I have searched all over the internet with no luck. right now I have an 08 sportsman with a great gear reduction, spins in anything!!! I will only buy a 4 wheeler I can put a gear reduction in. help would be much appreciated and a sub will be headed your way sir, great videos
@carmenvillebrun31487 жыл бұрын
thanks obama LOL
@mudmachines15387 жыл бұрын
I work for a Honda company an that is the worst Honda. That's my opinion but still better than can-am
@MudPuppyOffroad7 жыл бұрын
+Mud Machines what wrong with it...? It's the only honda sxs with low gears and a decent tranny
@mudmachines15387 жыл бұрын
Mud Puppy it's the shifting. I have drove several ones that was brand new an I've just see a lot of shifting problems out of them. But by the way ur videos are alsome
Hey dude, couple quick questions.. 1) Do you work as an engineer? 2) I'm a junior in high school and I am looking into finding a nice little 420 but don't plan on running gear reduction.. Recommendations for tires?
@micahbrown9207 жыл бұрын
Can-ams are good up just half to know how to drive it!!
@atvdirtbikeoff-road82907 жыл бұрын
micah brown my outlander 800 has never been in the shop and it is 7 years old