SOLIDWORKS Simulation - How to Apply an Orthotropic Material Model Type

[@lilanedaria]

Excellent video, that's exactly what I was looking for.

[@Chouby3]

Hello ! Thank you for this introduction video :) I would like to know if there is a possibility to simulate an assembly in which we define a reference geometry for each individual part. I am trying to simulate a wood structure in which beams are oriented in different directions.

[@Dont_Gnaw_on_the_Kitty_1]

Thanks for this video, very informative.

[@goengineer]

Glad it was helpful!

[@mariopersaud6703]

Hi im an engineering student. I was wondering if you can help. I am trying to analyse a situation of using a cheater bar on a wrench. I have a nut that is fixed and a wrench on it with a pipe over it. I was wondering if you could help with the correct boundary conditions or mates and for to analyze. Or if I could replace the cheater bar with forces.

[@goengineer]

Hi Mario, The setup of this analysis is going to be far too complex to describe in the comments section of our KZbin channel. We would encourage you at this point to approach the technical department at your local SOLIDWORKS VAR to gain personal assistance from them on making this setup.

[@mariopersaud6703]

GoEngineer what's a VAR lol

[@goengineer]

Mario, A VAR is a Value Added Reseller. It is who you purchased SOLIDWORKS from. Who sold you SOLIDWORKS?

[@jerryjin9964]

solidworks 2018 doesn't show the selection box of ''reference geometry'

[@goengineer]

For an issue like that the best thing to do is contact your VAR's technical support team. They can look at your specific set up and work to get a resolution.

[@muchammadjamil8688]

is solidwork have facility to setup Orthotropic thermal conductivity ? thanks

[@goengineer]

Yes, Solidworks can generate those material properties help.solidworks.com/2023/english/SolidWorks/cworks/c_isotropic_orthotropic_materials.htm?verRedirect=1

[@muchammadjamil8688]

Halo Sir, I would like to ask you to setup orthotropic Thermal conductivity ? I am very thanks full while you willing to help. thank you

[@goengineer]

Yes, Solidworks can generate those material properties help.solidworks.com/2023/english/SolidWorks/cworks/c_isotropic_orthotropic_materials.htm?verRedirect=1

[@DGmechanics]

Hello Can you please help me to find out the Properties of the Pine, (General properties for simulation). I need the information that can help me to do solid works simulation/analysis. Information required like, Elastic Modulus , Poisson’s Ratio , Mass Density & Yield/Ultimate Strength etc... I gone through many websites sites but i am not sure which is the accurate value to take. So,please help me out. Thanks in advance for your help.

[@odysseasa8542]

Hello. I would like to ask you... How to apply non-uniform thickness laminate composite material material in my study?(certain layers - variable thickness) I will appreciate if you answer or make a video! One more question, how to apply more than 50 layer? (solidworks fea is up to 50 layers)

[@yashnagar4042]

Can you give me hint about composite material

[@odysseasa8542]

@@yashnagar4042 Hello! I am not sure if my knowledge is enough to help you, but yes I will be happy if I can...