I always just put a little sealant around the old gaskets and leave them alone with mine I've ground right back to the screw head on those rear transfers to open up that bend
@Fueler Жыл бұрын
Great video and don’t worry about the crank. Stuff happens to the best of us.
@customcutter1002 жыл бұрын
Great video, love my 350's good power to weight ratio. I made one of the "home made hose clamp tools" and clamp the boot. Just grind off the plastic ears and leave the rest of the plastic to protect the rubber boot. I wouldn't put it on a saw I was selling, but for my use I always have a hose clamp that fits, and holds better than store bought clamps.
@truegritbulldog3 жыл бұрын
Great stuff! Really cool to see other folks bloopers.... Thanks for sharing.
@larryreno82933 жыл бұрын
I can say this with absolute certainty, you will never make that mistake again. Some of the best lessons are usually the most painful. It’s better than an expensive mistake!!! Lol
@simpleman42243 жыл бұрын
We all have a brain fart from time to time! Thanks for your honesty!👍👍👍👍👍🇺🇸🇺🇸🇺🇸🇺🇸🙏🙏🙏🙏😌😌😌😌
@davidellis3593
At
@edbartlett6348
That ls a 1998 350 case 1st year of that model.. I’ve got one original 44mm piston.. correct me if I’m wrong though.. I like your attention to detail.. mostly
@AndyAlaska375 Жыл бұрын
Some good tips specific to the Husky 350. Much appreciated. 👍
@philliphall5198
Well I left ground strap off once and I went to coffee pot and drink it all 😅
@johndoe-ko8nu
Great video i build saws too i use easy off oven cleaner to dissolve the carbon on the dome heat the cylinder first then apply probably have to reapply a couple times
@oldbowsaw9001 Жыл бұрын
I did that except I was getting rid of a new china carb that had been put on a echo cs 4400. Bad carb had been removed months ago--sorta ticky getting gaskets,linkages etc lined up.. Got it back on -all happy-good job then looked around and saw my new carb just sitting there nice and quiet--felt silly then got it right 2nd round.
@chrisyerp174
Great video just got me a 350 mint condition bout to do some mods awsome video
@nickywalsh84924 жыл бұрын
When I see the intake mod I thought that was worth while .I was hoping a 372 clamp would work then I popped up in writing...great tip..
@paulcondie2520 Жыл бұрын
Can't you just take off the plastic clamp on the intake boot and replace it with a regular hose clamp the proper size? Thanks
@petergdk2 жыл бұрын
Thank you sooooo much.
@Pef2733 жыл бұрын
The piston clip ring can come out while running. Just had a saw in its first year of use loose the clip. Which ripped up the piston wall when it got caught on the gap in the piston ring.
@raptorshawn2 жыл бұрын
Just curious as to what a job like this would cost a guy. I've got a couple 350s and wanted to know if it would be cheaper to buy a bigger saw or have a 350 ported and worked on by a magician like yourself.