Sorting out the EMCO stand.

[@shaun30-3-mg9zs]

This lathe is going to look better than new, your doing a cracking job. Great video, take care

[@CliffsShed]

Thanks definitely seeing the light at the end of the tunnel! ATB, Cliff

[@angelramos-2005]

Good cleaning,Cliff and very good grinder.Thank you.ATB.

[@CliffsShed]

Cheers Angel, one day I'll learn to weld! ATB, Cliff

[@philhermetic]

looks really good Cliff! People don't realise how much work goes into repainting stuff like that! Phil

[@CliffsShed]

Yep, everything consumes the minutes on a nuclear scale!!!! ATB, Cliff

[@eyuptony]

It's looking like a new lathe Cliff. 👍

[@CliffsShed]

Cheers Tony, Hope it performs like one! ATB, Cliff

[@retromechanicalengineer]

It looks really good Cliff. I've got the same stand but it had to be slightly modified to fit my older machine. It's not as shiny as yours!

[@CliffsShed]

Shiny, but close up its not so clever! Got a bit happy with the flap wheel!!!! ATB, Cliff

[@RustyInventions-wz6ir]

Very nice work sir

[@campbellmorrison8540]

Ive done up my emco stand, Im sure they built in some rust into some of the panels but anyway I found some suitable rubber from a panel beaters supplier who has a whole range of rubber extrusions

[@CliffsShed]

Cheers, I found some stuff on the internet, can't even remember where now, but it looks similar! ATB, Cliff

[@RetroSteamTech]

Great job Cliff 👍👍👍 Must have taken you ages to clean all that paint off. Cheers, Alan.

[@CliffsShed]

It bloody did Alan! :-) ATB, Cliff

[@77miketodd]

Starting to look good. Gonna get myself a TIG torch and give it a go.

[@CliffsShed]

Cheers Mike,

[@65cj55]

Looks good Cliff, Vevor have good cheap adjustable castors with a wind down foot, i put them on my Mill, Winkys Workshop done a video on them.

[@CliffsShed]

Cheers for that, I think I've found the castors, can't find winked video though?,, ATB, Cliff

[@ThePottingShedWorkshop]

I've got to say, that welding is worse than mine, and I'm pretty sh!te at TIG welding. I see you use the same cleanup technique as I do, namely grind it back till it looks decent! Anyhow, it turned out pretty good in the end, so nice one!

[@CliffsShed]

God help anyone who's welding is worse!!!!:-),,, Can't beat a good flap wheel!!! ATB, Cliff

[@markloving11]

Your tungsten tip needs to be kept clean an at a sharp point, that’ll get you a better result

[@CliffsShed]

and I think I might need to learn to weld!!!! :-) ATB, Cliff