Spool Winder Assembly Instructions

This is a quick assembly guide for the filament spool winder.
For more Design and 3D Printing, Visit us at:
- www.V3Precision.com
- / v3precision
- / v3precision
- www.printables.com/social/459...
👍👍Help me keep this channel alive! Any donation is priceless and greatly appreciated!
www.buymeacoffee.com/v3precision
As an Amazon Associate I earn from qualifying purchases with no extra cost to you.

[@EC-gy9pv]

Thank you for sharing! Your model is more advanced than others. I had a couple of questions, but found you on Printables and you’ve explained very clear what’s needed. 😍

[@kevinb9790]

Congrats on being highlighted on the Bambu site!

[@renelewis4558]

I am about 75% of the print. I wanted to do this print for a while and now have enough rolls to now need it. Thanks for sharing.

[@jessanderson6252]

I have an issue with the empty spool not gaining traction and spinning on its axes..... help......

[@Blitz-Gaming]

Just in the process of printing this now, cant wait for it to be finished!

[@millerliteman-2617]

I always seem to have an issue with threads not working. But im not sure if it's something I'm doing wrong or the files.

[@poppin_freshgaming4334]

I'm printing this in PLA now. I absolutely hate supports, so I've cut the middle section out of the rear and middle assembly (not using the front for now) so I can print them flat rather than upright with support. Should print faster and rather than using support, I am using 4 walls, 4 top and bottom layers and increased the infill to 20%. I might get a little sag on the now vertical screw holes, but a drill bit will take care of that if needed. I realize I will need to get the spacing correct before screwing down to a small piece of plywood, but that shouldn't be too hard.

[@jasongooden917]

I'm printing the worm gear right now

[@richthemagicman]

I’m thinking it would be nice if you showed us how it worked in reality. It’s a great video, but it would be nice if you gave us a demo is that possible?

[@user-db3ug5ly1w]

Could you please show out the size (long, wideth and height ) of the base wood ?

[@ArtisanDepot]

This was my first spooler. It worked fine at first, but it eventually locked up on me so I’m printing a different model.

[@judeffr]

Did the new one work better? If so please link me to it

[@crazygengargaming3802]

anyone else have problems with the thread

[@o22.]

Lots of issues yes

[@jasongooden917]

my files look so different

[@bobh0905]

Which thread? The central reciprocating thread, or the end nut threads?

[@DanoFPV]

This is... a complicated print.

[@yansheng9901]

Complex and cumbersome, many parts are unnecessary