One tip id recommend every Sprinter owner do is buy the Cerakote trim kit and apply it to all outside plastics. Lasts a VERY long time and keep everything looking better than new. Ive had my plastics coated for two years and they still look brand new
@trentdavey7792 ай бұрын
Also, check your bottle jack and the hi-lift base to make sure it raises the van enough to change the tire. Aftermarket tires and lifts may exceed the stock bottle jack’s capability. Find out in your driveway and not on the trail.😂. I carry some extra wood blocks and also have the H1 scissor jack just in case. Great video!
@srt53212 ай бұрын
Thank you! Great tips. I think I’ll try ALL.
@Clint30292 ай бұрын
Checking your jack before you leave on a trip and having leveling blocks/ramps is a great idea!!! I was recently in Colorado about 12,000 ft. on a trail few people used, when I had a tire sidewall rip apart. I got my hydraulic jack out only to find that it would only raise about 2” before it wouldn’t lift anymore, despite my checking it several months earlier after I purchased it. I raised my truck 2” and placed leveling blocks under the rear axle, lowered the jack on the blocks, placed more leveling blocks under the jack raising it and raised the truck another 2”. Then more blocks under the axel, lower the jack and repeated several times. I also needed my Anderson ramps placed under axle and repeated till the tire barely cleared the ground. Now, my departing checklist includes to make sure the jack works!
@KenCollier2 ай бұрын
Great ideas, John. Thank you. I love the silicone bracelet idea for reducing rattles. We've been using neoprene beer koozies for this in our Revel, but I will definitely start using those bracelets.
@borandell99152 ай бұрын
Very beneficial. I've already utilized the jack block trick. Thanks John.
@MrAustin6022 ай бұрын
A practical van guy that’s local to me, great work.
@rustyharvey34812 ай бұрын
Great tips I'm learning so much about owning my revel
@iglapsu882 ай бұрын
Yeah I drove off plugged in once. Wasn't too bad, but could have been way worse. Thanks for the tips.
@mtnride49302 ай бұрын
Once again great tips, I really like the shin saver.
@Korea-Heaven2 ай бұрын
Perfectionist..! Thank you for the tips.
@ericdanielson41772 ай бұрын
I have those leveling blocks. Sometimes the shim part can be difficult to get out. I drilled about a 1/2 in hole in the back of the shim, put in 18 inches of webbing, slid a fender washer over the loose ends and then tied a knot. Now it's easy to grab the webbing loop to pull the shim free.
@owloffroad2 ай бұрын
Great idea. We have the same problem sometimes
@seib63242 ай бұрын
Excellent video thank you very much
@markcoker14712 ай бұрын
Thanks for all the fixes
@willofthemaker2 ай бұрын
Great video as always. Love the tips videos. Talhanks John
@craiglyndaziegenhagel43442 ай бұрын
You are the real deal! Thanks for all the tips.
@mitchgroff263Ай бұрын
It is a great video thanks for the great information and well delivered. This is exactly what I was looking for.
@lifeholdstrategic2 күн бұрын
I’ll bet you could design and 3d print some covers for the seat brackets to prevent the shin smash.
@lindakrusyna72752 ай бұрын
Very helpful hints, thank you.
@ulfmeijer95142 ай бұрын
Great stuff. Really appreciate these tips and tricks. Keep it up! Greetings from Cornwall, England.
@lyfandeth2 ай бұрын
Many bottle jacks leak, so buying a spare pint of hydraulic oil and keeping it with the jack is a good idea.
@jvonarend2 ай бұрын
Thank you very much!!
@lorifrancis87013 күн бұрын
I have a 2021 sprinter van that in the hard rain a couple of weeks ago and I add this rain was unprecedented for four straight days. There was a puddle on the step as you get up to the driver seat, looking at the van with the driver door open it was a little puddle in the left-hand corner, not on the passenger side just the driver side Have you ever seen that and if you have any suggestions and stopping that water, it ran straight out it wasn’t a big deal, but I can’t figure out where it was coming from
@Met201101MАй бұрын
Great content and info! I have a quick question: how would you lower the seat height with the OEM swivel seats? thanks!
@owloffroadАй бұрын
You can’t. I took the swivel out from the driver seat and used a small spacer
@Met201101MАй бұрын
@@owloffroad Thanks for the response. That is disappointing. I was hoping to find a way to lower the base and still use the swivel.
@scotttannehill35332 ай бұрын
Great information, but I must say, I really cringed when you started sending metal / sparks all over the cabin of a brand new van? I would recommend covering the seats and floor, then collecting every piece of rust inviting metal.
@marylore61342 ай бұрын
Please let us know what you are using to mount your bubble level and where you attach it?
@lyfandeth2 ай бұрын
Odd the way German luxury brands always have naked exposed seat tracks. Even Opel left them bare and uncovered. And meanwhile, cheaper US and Japanese cars always cap the nasty bits.
@rod1147Ай бұрын
does the Rain X deter bug splatter?
@owloffroadАй бұрын
I wouldn't say it deters it but probably makes it clean off more easily with the window sprayers