SRAM/Sachs T3 hub gear reassembly (some out of shot - oops)

[@andre-francoisbourbeau7496]

Thank you kindly for putting this on line. Extremely well made video and very helpful!

[@fintanb]

Great step-by-step guide, thank you for posting

[@evhentkachenko689]

🔥🔥🔥 "When you are is an engineer!" Thanks!! 🙇‍♂👍

[@RolingRandom]

There should be a little metal cap on top of the spring. It's rather annoying to assemble because it gets pushed trough the cage with ball bearings. I believe later Sram T3 models had a "cap" integrated in to the cone. A wonderful improvement if you ask me :)

[@RoryMacdonald-pfff]

Yes, this one didn’t have a cap, and I’ve seen this on a couple of these older units now. Not sure if some came from factory like that or just bad luck from previous services.

[@maxc5492]

@@RoryMacdonald-pfff Mine (from 2004) didn't have a cap; it was the 1st service. No noticeable wear after 18 years! A 22mm cone spanner makes everything much easier 🙂 Thank you for the video, BTW.

[@hoogerbooger5862]

As the hub is poorly sealed, I can't help thinking it's better to use plenty of semi-fluid grease ( Sturmey Archer). Yes it will collect some dirt, but better to have to service it again ( SRAM recommend every two years)......that the internals rusting.

[@volkerblock]

I had no retaining cap for the thin spring too.

[@rs-5830]

At minute 7.43 the washer that was seen at the top left (small washer) simply stops being seen, it is precisely that washer that I don't know where it goes, and I am trying to assemble the equipment, where does that washer go?

[@RoryMacdonald-pfff]

That thrust washer goes into the lower body of the planet carrier, *before* the planet gears go back in. If you stop the video at 11m09s you can make out the washer in its installed location. I realised my mistake straight away, but my recording of correcting the error didn’t work out.

[@RoryMacdonald-pfff]

Maybe a better view of the installed washer at 8:04 … go back to 5:30, the washer simply goes into that lower chamber before putting the planet gears in.

[@rs-5830]

@@RoryMacdonald-pfffthanks a lot for the help. Now i can understand and put it where ir goes, ❤

[@cbpaton53]

... found the video helpful Rory as I'm doing the same job, thanks. is it possible to put in a link to the German company that supplied the bearings?

[@RoryMacdonald-pfff]

Hi Charles - I bought mine from www.retrobikefranken.de/ - but I had also found them in stock at www.daszweirad.de and hollandbikeshop.com/ Good luck with the service!

[@rogercantwell3622]

A thrust washer disappears from the left of the frame just after 7:50. Where did it go?

[@RoryMacdonald-pfff]

Ah, excellent spot - and a bad edit on my part. It goes into the lower body of the planet carrier before the planet gears go back in. I forgot to insert this during the 1st pass and then went back but hadn’t recorded that. You can kind of make out the washer at 8:03

[@RoryMacdonald-pfff]

Better view of the thrust washer at 11:09

[@cbpaton53]

... perfect, thanks :)

[@erikaugustmller2346]

Hopeless to look out of the picture-area Hands in front of tecknikal parts

[@RoryMacdonald-pfff]

Glad you enjoyed the free video.