Stacked Ring

[@CrossCutCreations]

That's a fun turn for sure. The laser cut blanks are always visually fun.

[@RJBWoodTurner]

Thank you Robert, Did you buy any at the show? Regards, Bob

[@russcomstock5871]

The only way to prevent that bleed is make a final pass with a sharp skew and not sand at all. Very cool blank - nice job!

[@RJBWoodTurner]

Thank you Russ, Gonna chalk this one up as a learning experience. Regards. Bob

[@matthewrichards5941]

Nice pen, Bob! I love the pattern on that one. It was great visiting with you at MATE. My son Andrew is still raving about the show. I picked up one of Rick's puzzle piece blanks and look forward to turning it.

[@RJBWoodTurner]

It was great chatting with you too. You’re gonna love that blank. They are amazing. Regards, Bob

[@kwstasantwniou243]

Very nice pen at the end ,good work and a beautiful blank Bob ! I am sure these kind of blanks they need an extreme care.

[@RJBWoodTurner]

Thank you Kwstas, The blanks are delicate but worth the extra care. Regards, Bob

[@Bob_H]

Bob look at the video frame by frame from 4:16 to 4:18 as the blank makes the first revolution. It is very striking the difference the wheel makes.

[@RJBWoodTurner]

Thank you, Those buffing wheels are amazing and I use them on every blank. Regards, Bob

[@georgewilmore7599]

Nice tip on preventing bleeding.

[@RJBWoodTurner]

Thank you George. Regards, Bob

[@alanmullock381]

What a beauty Bob❤👍👍👍👍👍👍👍👍👍👍👍👍😎😎😎😎😎😎

[@RJBWoodTurner]

Thank you Alan. Regards, Bob

[@wesbiehn4443]

Wow, I'd be super proud to carry that around with me everywhere I go if I were you, in spite of the little "blemish" on the one end. I'd say that's hardly noticeable and I used to turn pens myself and am SUPER PICKY!

[@RJBWoodTurner]

Thank you, It is a beautiful pen. Regards, Bob

[@angim8984]

That's a really nice blank.

[@RJBWoodTurner]

Thank you Angi. Regards, Bob

[@paulwaldrop]

nice design on the pen. Hope the show went well.

[@RJBWoodTurner]

Thank you Paul, The show was awesome!!! One of the best I’ve been to. Regards, Bob

[@WoodenItBeNice]

Nice blank and pen Bob. Take care. Cheers, Huw

[@RJBWoodTurner]

Thank you Huw. Regards, Bob

[@tedspens]

Now that is one nice lookin' pen! Too bad about the bleeding, maybe sanded through the CA at that end. It's still a nice addition for the personal collection.

[@RJBWoodTurner]

Thank you Ted, I’d be worried about additional sanding as I hit the bushing so closely that you can’t feel where the blanks ends and the pen component begins. I’m worried if I sand, it will render the blank lower than the component and you would feel the transition. Regards, Bob

[@markduggan3451]

Nice looking pen.

[@RJBWoodTurner]

Thank you Mark. Regards, Bob

[@leliaguinn5307]

nice pen

[@RJBWoodTurner]

Thank you Lelia. Regards, Bob

[@davenewkirk1642]

Great looking pen, what is the reason you change to your turning bushings to micro mesh?

[@RJBWoodTurner]

That way I can make sure I Micro Mesh back down to the bushings to ensure the pen components have a perfect fit. Regards, Bob