Stahlwerk mig200ST first tests - part 2

Part 2 of initial 3 videos were i unbox and test the Stahlwerk MIG 200ST welder.
If you want to understand my choice for this welder see the video in the link below.
• Welder choice selectio...

[@thegreenwulf8733]

Hello guys, I have the Stahlwerk Mig 135 ST IGBT and im from germany 🤙. Amps is Wirespeed too and the voltage must be higher so 2-3Volts in my experience. So i use for 1mm material 30 Amps with 17.5 Volts, for 2mm 80 amps with 20-21 volts and 3mm with 22 volts. Hopefully i can help you 👍

[@maycodesignandengineering7514]

Hi The GreenWulf, i have made several more videos were i explain new things. Perhaps good to watch them and see if you have more feedback or learn something. Thank you!

[@stefan8145]

Good morning, I was wondering if you discovered a way to reduce the thickness of the weld. 🤔

[@stefan8145]

I'm thinking to buy the same welder as yours, but I'm still analysing... Budget 700€.

[@maycodesignandengineering7514]

Good morning Stefan, not yet i hope next week i have a video on some more welding and testing. i do not fully onderstand it to be honnest sometimes it welds fine when the material is cold, but it will not weld nice once the material is hot. The first dail is mainly to help with the start. I used the manual information, but keep comming back to much higher setting to weld nicely. (17V and 120A suggested for example, i weld with 19V and 150A)

[@stefan8145]

@@maycodesignandengineering7514 Thanks for your reply, I will follow up your upcoming videos, hopefully the solution is closed. 😊